Carrier Roller Top Roller

Replacement carrier roller top roller for Lovol RG service. Verify part number RDL1401000033/50 and contact us for ordering support.

What is the Carrier Roller Top Roller?

RDL1401000033/50 is held on a historical real-part record for the Lovol RG carrier roller that supports the upper track run. Several RG catalogues carry carrier roller sections, but this reference was not resolved to one illustrated line, so the worn roller stays the size reference before ordering.

Filed number and measurement check

Part NumberRDL1401000033/50
Part TypeCarrier Roller Top Roller
BrandLovol
Machine SystemTrack Upper Run Support
Evidence SourceHistorical Lovol real-part record for this carrier roller
Evidence BoundaryCarrier roller sections appear in several RG catalogues; this exact reference was not matched line by line
Ordering CheckCompare roller outside diameter, width, flange shape and mounting stem with the worn roller

Role in the track upper run support

The carrier roller sits along the top of the track frame and holds the upper run from sagging onto the frame. It turns with the track instead of driving it, so its job is to keep the chain aligned and to stop the links from rubbing the frame while the machine reverses or turns on soft ground.

Wear and fault symptoms

A failing carrier roller is heard as a knock or rumble that follows track speed, felt as a track that sags and slaps the frame, and seen as a flat spot on the roller face, a leaking seal with oil or mud packed around the hub, a seized roller that scuffs the links, or a worn stem and loose mounting. A worn track link or a loose track tension can sound the same.

Fitment and ordering check

Measure the removed roller across its outside diameter and width, then check flange shape and the mounting stem against RDL1401000033/50. Compare it with the roller on the opposite side of the same machine as well, because an uneven pair will steer the track and wear the links faster.

Repair planning notes

Lift and block the machine per the service procedure, release track tension and clean the area before removal. Inspect the mounting stem, bore and seal seat for damage that would ruin a new roller, and confirm the track links and pins are serviceable. After fitting, set track tension as specified, run the machine straight and then turn both ways, and listen for the earlier knock before returning to wet ground.

See the chassis track category for the rest of the undercarriage group, then compare these linked track parts: Track Roller (RV0140113005), Guide Wheel Balance Wheel (RDL1401000016).