Vertical Auger Weldment – RGV4301030031a

Replacement vertical auger weldment for Lovol RG grain flow service. Verify part number RGV4301030031a and contact us for ordering support.

SKU: RGV4301030031a Category: Tag:

What is the Vertical Auger Weldment?

RGV4301030031a is filed as the vertical auger weldment that lifts grain out of the Lovol RG tank during unloading. The reference is retained from a stored Lovol record. The extracted catalogues describe auger and unloading tube sections without an exact match for this suffix letter, so the removed weldment stays the reference for flight size and shaft ends.

Evidence and ordering facts

Part NumberRGV4301030031a
Part TypeVertical Auger Weldment
BrandLovol
Machine SystemGrain Tank Unloading Auger
Evidence SourceSaved Lovol reference RGV4301030031a
Evidence BoundaryExtracted catalogues show auger and unloading tube sections but no exact RGV4301030031a line
Ordering CheckCompare flight diameter, pitch, shaft ends and weld joints with the removed vertical auger

Role in the grain tank unloading auger

The vertical auger turns inside the unloading tower and raises grain from the tank floor to the horizontal unloading auger. Flight diameter and pitch control how much grain is lifted per turn, so a worn or damaged flight reduces unloading speed even when the engine and drive are healthy.

Wear and fault symptoms

Problems show as grain that stops rising, very slow unloading, a rumble or scraping from the tower, grain cracked or broken at a high rate, a flight edge worn thin or torn, weld cracks at the lower bearing area, a shaft that no longer turns freely, or grain left in the tank corner after unloading. A slipping drive, a blocked outlet or a foreign object can copy the same symptoms.

Fitment and ordering check

Match RGV4301030031a to the removed auger on flight diameter, pitch and direction, plus shaft ends and weld joints. The lower and upper shaft ends must engage the bearings and drive the same way; an auger that is right in diameter but different at the ends will not mount correctly even though it looks alike.

Repair planning notes

Empty the tank and lock out the unloading drive before opening the tower, according to the service procedure. Inspect the lower bearing, drive coupling and outlet for the cause of the original damage, and remove any stone or debris before fitting the new auger. Turn the assembly by hand to confirm freedom, then run the unloading system empty, check for scraping, and finally test with a partial grain load while watching for cracked grain.

Browse the threshing and grain system category for grain flow components, then review the linked conveyor and feed plate entries: Conveyor Slat Chain Harrow – RGV3108010009, Feed Plate Weldment – DV01201080002.