Eccentric Adjusting Shaft W2.5E-01D-01-02A-13 (850 mm, 25 mm Diameter)
The W2.5E-01D-01-02A-13 eccentric adjusting shaft is 850 mm long, 25 mm in diameter and 3.2 kg in mass, used for offset adjustment in the header mechanism.
Eccentric adjustment data
| Part number | W2.5E-01D-01-02A-13 |
| Component | Eccentric adjusting shaft |
| Length | 850 mm |
| Diameter | 25 mm |
| Mass | 3.2 kg |
| Function | Eccentric adjustment |
Eccentric adjusting shaft role
The eccentric shaft uses offset geometry to change the adjusted position of the linked header part as it rotates.
Eccentric adjusting shaft differences
This shaft is defined by its eccentric adjustment role. A telescopic teeth shaft supports teeth rather than setting an offset position.
Eccentric adjusting shaft installation
Mark the original adjustment position before removal. When reinstalling, keep the eccentric surfaces clean and align the adjusting linkage without altering unlisted settings.
After fitting, move the adjustment through its range and confirm the linkage does not lock or contact the frame.
Eccentric adjusting shaft wear checks
- Flat spots on eccentric surface
- Worn adjustment seat
- Bent shaft
- Corroded linkage point
- Loose retaining feature
- Incorrect adjustment after repair
Eccentric adjusting shaft ordering checks
W2.5E header adjustment mechanism.
Identify W2.5E-01D-01-02A-13 before ordering, then confirm the 850 mm length, 25 mm diameter and 3.2 kg mass.
Match the eccentric feature, adjustment points, diameter and length with the removed shaft.
Eccentric adjusting shaft related parts
Eccentric adjusting shaft questions
Should the original setting be recorded?
Yes, recording the original position helps return the header mechanism to its known setup.
Can a plain 25 mm shaft replace it?
No, the eccentric feature is required for adjustment.
Identification of W2.5E-01D-01-02A-13 before ordering
Use this eccentric adjusting shaft when adjustment is stiff, inaccurate or affected by wear at the offset surface.





