Feed Plate Weldment – DV01201080002

Replacement feed plate weldment for Lovol RG grain flow service. Verify part number DV01201080002 and contact us for ordering support.

SKU: DV01201080002 Category: Tag:

What is the Feed Plate Weldment?

DV01201080002 is recorded as the welded feed plate fitted at the intake of the Lovol RG feeder. The number is taken from a stored real-part record. Because the extracted catalogue text only names the feed plate section, the outline and mounting pattern of the removed weldment remain the deciding check before ordering.

Evidence and ordering facts

Part NumberDV01201080002
Part TypeFeed Plate Weldment
BrandLovol
Machine SystemFeeder Intake Throat
Evidence SourceArchived Lovol part entry for DV01201080002
Evidence BoundaryOnly the feed plate section name appears in the extracted catalogue text; no exact DV01201080002 line was located
Ordering CheckCheck plate outline, weld bosses, bolt hole pattern and throat angle against the removed weldment

Role in the feeder intake throat

The plate forms the lower surface of the throat that guides crop from the conveyor into the threshing area. Its angle and smoothness set how evenly the crop layer enters, so a distorted or holed plate changes loading on the drum and shows up as uneven threshing long before the drum itself is suspected.

Wear and fault symptoms

Faults on this weldment appear as crop hesitation at the throat, straw building up on the plate, a rattling or knocking sound from the feeder, wear holes or cracks along welds and mounting bosses, a plate edge bent down by a stone, or grain losses that begin right after the conveyor. A loose conveyor chain or a worn drum FeedPlate area can produce a similar uneven feed.

Fitment and ordering check

Compare DV01201080002 with the removed plate on overall outline, weld boss positions, bolt hole spacing and the throat angle. Look for a plate that is bowed or has been straightened after a blockage; a plate that no longer matches the mounting plane will not seal against the feeder walls and will leak crop around its edges.

Repair planning notes

Remove crop and release the feeder drive before starting, following the service procedure. Inspect the feeder walls, side seals and conveyor end for damage that could have caused the original crack, and clear any foreign object before fitting the new plate. After assembly, turn the feeder by hand to confirm clearance, then run it empty and check for rubbing before a light crop load. Recheck bolt tightness after the first working hours.

Check the header and conveyor category for adjoining intake hardware, then open the linked chain and auger pages: Conveyor Slat Chain Harrow – RGV3108010009, Vertical Auger Weldment – RGV4301030031a.