CVT Belt 3115

Replacement cvt belt 3115 for Lovol RG service. Verify part number 3115 and contact us for ordering support.

What is the CVT Belt 3115?

This page covers the Lovol variable speed belt filed under the short reference 3115. The number comes from a stored part entry, not from a catalogue line, and short numeric references are easily confused with section or size codes, so the belt itself and the machine parts book decide the order.

Short reference and confirmation steps

Part Number3115
Part TypeCVT Belt
BrandLovol
Machine SystemVariable Speed Belt Drive
Evidence SourcePreviously filed Lovol part entry using this short reference
Evidence BoundaryShort numeric references are hard to trace; no catalogue row reading 3115 was found for this belt
Ordering CheckTake the old belt to the parts book and compare section, outside length and cord condition before ordering

Role in the variable speed belt drive

The belt links the drive and driven pulleys of the variable speed unit and carries torque while pulley pitch changes with working load. Because the belt rides higher or lower in the pulley groove as speed changes, its section shape and length control the ratio range the machine can reach.

Wear and fault symptoms

A tired belt shows as a slip under load, a burning rubber smell after heavy work, speed that drops when the header or separator loads up, cracks across the ribs, exposed cord, a belt that has stretched and no longer reaches the pulley edge, or black dust packed around the pulleys. A glazed pulley face and a weak tension device cause the same slip.

Fitment and ordering check

Take the removed belt with its reference 3115 to the parts book and compare section profile, outside length and the number of ribs against the illustrated entry. Do not order from the short number alone if the groove width or length differs, because a belt that sits at the wrong height changes both ratio and heat.

Repair planning notes

Inspect both pulley faces for glazing, grooves and worn shoulders before fitting a new belt, and check the tension device moves freely. Fit the belt without prying it over the pulley shoulders, set tension per the service procedure, then run the machine through the full speed range unloaded. Recheck tension and temperature after the first load, because a belt that runs hot early is usually too tight or sitting wrong in the groove.

Open the HST and hydraulic drive category to see the hydrostatic drive group, then review the linked HST and shaft entries: HST Hydrostatic Transmission 50cc, Transmission Input Shaft – DV01402010067.