Exhaust Pipe Weldment – RV03506020002/50

Replacement exhaust pipe weldment for Lovol RG engine service. Verify part number RV03506020002/50 and contact us for ordering support.

SKU: RV03506020002/50 Category: Tag:

What is the Exhaust Pipe Weldment?

RV03506020002/50 is held as a Lovol exhaust pipe weldment for the RG harvester engine bay. The number comes from a stored record rather than a resolved catalogue line, so the removed pipe remains the shape reference for bends, hangers and flange faces.

Reference record and ordering notes

Part NumberRV03506020002/50
Part TypeExhaust Pipe Weldment
BrandLovol
Machine SystemEngine Exhaust Routing
Evidence SourceFiled Lovol record held for this reference
Evidence BoundaryExhaust sections appear in the extracted catalogues, yet nothing matched this reference exactly
Ordering CheckCompare flange faces, bend angles, hanger points and pipe diameter with the removed weldment

Role in the engine exhaust routing

The pipe carries hot exhaust gas away from the engine outlet toward the silencing and outlet section. It also sets where the hot surface sits relative to wiring, hoses and the canopy, so a pipe bent to a different angle can heat parts that were never designed to run close to exhaust temperature.

Wear and fault symptoms

A failed pipe announces itself with a sharp exhaust note under load, soot staining around a weld or flange, a rattle from a cracked hanger, heat damage or a burnt smell near wiring, a whistle at a joint that the gasket no longer seals, or visible rust scaling through the wall. A loose manifold stud or failed gasket sounds similar and should be eliminated first.

Fitment and ordering check

Place RV03506020002/50 beside the removed pipe and compare flange flatness, the run of bend angles, hanger bracket locations and the pipe outside diameter. A weldment that matches at the flange but differs at a hanger will pull on the joint once hot, which is how the original crack usually started.

Repair planning notes

Work on a cold engine and follow the service procedure for removing the exhaust section. Inspect the manifold face, studs and gasket surface, and replace damaged fasteners rather than forcing the new pipe into place. Support the pipe before tightening, check clearance to wiring and hoses along the whole run, then run the engine and listen for leaks at the joints after warm-up.

Go back to the engine category for the engine assembly context, then read the linked turbocharger pages: Turbocharger J76G – T848010024, Turbocharger J55S – T74801003.