Turbocharger J55S – T74801003

Replacement turbocharger j55s for Lovol RG engine service. Verify part number T74801003 and contact us for ordering support.

SKU: T74801003 Category: Tag:

What is the Turbocharger J55S?

T74801003 carries the J55S designation on a stored Lovol turbocharger record. It is a different reference from the J76G unit and must not be treated as a substitute for it; no verified displacement, boost level or horsepower figure is published here since the catalogue text left this code unresolved.

Reference check before ordering

Part NumberT74801003
Part TypeTurbocharger J55S
BrandLovol
Machine SystemInduction Boost Circuit
Evidence SourceSaved Lovol turbocharger reference T74801003
Evidence BoundaryNo catalogue line resolving T74801003 was found; turbocharger sections were read as context only
Ordering CheckConfirm the old nameplate and compare housing flanges, wastegate or actuator type and oil ports

Role in the induction boost circuit

This turbocharger raises induction pressure on the engine it was matched to, so the compressor side feeds the intake while the turbine side absorbs exhaust flow. Because the two J-series references belong to different matchings, the correct starting point is always the nameplate and the machine the unit came from, not the family name alone.

Wear and fault symptoms

Symptoms reported for this type of unit include sluggish response below working speed, smoke that clears only at high load, oil traces at the compressor inlet, a metallic scrape when the shaft contacts the housing, a wastegate that sticks open or shut, low boost with a whistle at a loose joint, or an engine that derates under load. Air restriction and a leaking charge-air hose remain the first checks.

Fitment and ordering check

Confirm the nameplate on the old unit and compare T74801003 at the housing flanges, the wastegate or actuator type and the oil port positions. Note the machine serial reference as well: if the removed unit is a J76G, the J55S reference is not the correct replacement even when the housings look comparable.

Repair planning notes

Follow the service procedure for the engine, starting with air filter condition, charge-air hose integrity and exhaust restriction. Renew engine oil and filter, verify the feed pipe is clear and the drain flows, and prime the bearing before start-up. After fitting, let the engine idle without load, inspect for oil and exhaust leaks, then raise load gradually while watching smoke and boost response.

Return to the engine category for the wider engine parts set, then review the linked turbo and exhaust references: Exhaust Pipe Weldment – RV03506020002/50, Turbocharger J76G – T848010024.