Turbocharger J76G – T848010024

Replacement turbocharger j76g for Lovol RG engine service. Verify part number T848010024 and contact us for ordering support.

SKU: T848010024 Category: Tag:

What is the Turbocharger J76G?

T848010024 is stored as the J76G turbocharger reference for the Lovol RG engine family. The J76G naming is part of the existing reference and is not converted here into a verified flow, boost or speed figure; the extracted catalogues carry turbocharger sections with no line for this code recovered.

Nameplate and ordering record

Part NumberT848010024
Part TypeTurbocharger J76G
BrandLovol
Machine SystemCharge Air and Exhaust Drive
Evidence SourceArchived Lovol turbocharger entry T848010024
Evidence BoundaryTurbocharger sections are present in the extracted catalogues; the exact T848010024 row was not recovered
Ordering CheckRead the nameplate, then match turbine and compressor flange patterns and oil feed position

Role in the charge air and exhaust drive

The unit uses exhaust energy to spin a compressor that packs more air into the cylinders, which lets the engine burn more fuel and hold power under harvest load. Oil supply and drain keep the bearing cartridge alive, while the compressor and turbine housings keep the two gas paths separate.

Wear and fault symptoms

Watch for a drop in power with black smoke, a siren or whine that rises with engine speed, oil wetting the compressor inlet or turbine outlet, blue smoke after idling, a seized shaft that leaves the engine flat, or an actuator that no longer moves through its range. A clogged air filter, a boost leak at a hose joint and a restricted exhaust can look like a failed turbo.

Fitment and ordering check

Read the nameplate on the removed unit before ordering T848010024, then compare turbine and compressor flange patterns, oil feed and drain positions and the actuator arrangement. Two turbochargers can share a family name yet differ at the flanges, and a mismatch will not seal or feed oil correctly.

Repair planning notes

Investigate air filter restriction, boost hose condition and exhaust back pressure before condemning the unit, following the service procedure. Change the oil and filter, inspect the feed line for coking and confirm the drain is clear before fitting the new turbocharger. Prime the oil supply, keep the inlet covered until connection, then idle the engine briefly and check for leaks before applying load.

Use the engine category to place this unit in the engine assembly, then compare the linked exhaust and second turbo reference: Exhaust Pipe Weldment – RV03506020002/50, Turbocharger J55S – T74801003.