External Friction Plate – DV01402010096

Replacement external friction plate for Lovol RG drive service. Verify part number DV01402010096 and contact us for ordering support.

SKU: DV01402010096 Category: Tag:

What is the External Friction Plate?

DV01402010096 is an external friction plate listed for Lovol RG harvesters through a stored real-part record. The page limits itself to the plate role and inspection logic, because the extracted catalogue text mentions friction plate sections without an exact line for this number.

Evidence and ordering facts

Part NumberDV01402010096
Part TypeExternal Friction Plate
BrandLovol
Machine SystemFriction Clutch Pack
Evidence SourceStored Lovol record for DV01402010096
Evidence BoundaryCatalogue text names friction plate sections only; the exact DV01402010096 line was not extracted
Ordering CheckConfirm plate outside diameter, spline or lug pattern and pack position against the old plate

Role in the friction clutch pack

The external plate sits in the friction pack that connects or releases drive inside the transmission. In a wet pack several plates work together, and the external plate carries the outer engagement pattern while alternating with inner plates. Friction here decides how much torque reaches the gear train before slip begins.

Wear and fault symptoms

A worn or glazed pack shows as weak or delayed drive, a shudder when the machine starts moving, slipping under heavy load or on a slope, a burnt oil smell, dark oil with suspended material, or a drive that engages only after the engine speed rises. Low oil level, contaminated oil, a weak apply pressure path and a warped plate can all imitate plate wear.

Fitment and ordering check

Compare DV01402010096 with the removed plate for outside diameter, lug or spline pattern and pack position, then inspect the whole pack rather than one plate. Measure the pack against the service data and look for hot spots, glazing, cracking or a plate that no longer sits flat. Replacing a single plate in a worn pack usually shortens the life of the new part.

Repair planning notes

Work with the pack removed and cleaned so each plate can be inspected in sequence. Check the oil supply, cooler path and apply circuit for the cause of overheating before the pack is rebuilt, and renew the oil and filter afterwards. After assembly, test engagement at low load, watch for the earlier shudder, and confirm the oil temperature stays normal during the first working hours.

Browse the HST and hydraulic drive category to see how the pack shares the drive with other components, then check these linked parts: Transmission Input Shaft – DV01402010067, HST Hydrostatic Transmission 50cc.