Header Lift Cylinder Assembly – DV01602000001

Replacement header lift cylinder assembly for Lovol RG service. Verify part number DV01602000001 and contact us for ordering support.

SKU: DV01602000001-OEM Category: Tag:

What is the Header Lift Cylinder Assembly?

DV01602000001 names the Lovol header lift cylinder assembly used to raise and lower the cutting table. The stored record carried an additional suffix marker after this base number, which is why the page presents the base number used by the existing product name and asks for a physical comparison instead of promising an exact catalogue match.

Number source and fitment points

Part NumberDV01602000001
Part TypeHeader Lift Cylinder Assembly
BrandLovol
Machine SystemHeader Lift Hydraulic Circuit
Evidence SourceArchived Lovol record filed with a suffix marker after the same base number
Evidence BoundaryThe stored entry carried an extra suffix marker; the base number above is what the existing product name uses, and no catalogue row was matched
Ordering CheckCompare closed length, stroke, rod end and port positions with the removed cylinder

Role in the header lift hydraulic circuit

The cylinder converts hydraulic pressure into the force that lifts the header and holds it at cutting height. Rod and bore size set the lifting force, while the valve and circuit decide how smoothly the table follows ground contours, so a tired cylinder usually shows up as a header that creeps or drops rather than failing outright.

Wear and fault symptoms

Faults include a header that lifts slowly or not at all, a table that sinks after the lever returns to neutral, oil at the rod seal or around the gland, a bent or scored rod, a cracked weld at the rod end, uneven lift on one side, or a cylinder that shudders as it moves. Low oil level, a weak pump, a leaking hose or a faulty valve can produce identical behaviour.

Fitment and ordering check

Before ordering DV01602000001, measure the removed cylinder closed and extended, compare rod end type, pin diameter and port positions, and check which side of the header it serves. A cylinder with the right stroke but a different rod end will not pin to the header frame, and one with ports in another place will fight the hose routing.

Repair planning notes

Support the header and release hydraulic pressure per the service procedure before opening the circuit, and keep the area clean because contamination is what usually destroys a new cylinder. Inspect the hose, valve and relief path for the cause of the original failure, and check the frame pin and bush for wear. After fitting, bleed the circuit, cycle the header through its full range without load, and confirm the table holds height before cutting.

Visit the header and conveyor category for the header hardware around this cylinder, then open the linked conveyor and feed plate pages: Conveyor Slat Chain Harrow – RGV3108010009, Feed Plate Weldment – DV01201080002.