Active Shaft Weld W2.0B-01B-01-02-03-00 (550 mm, 20 mm Diameter)
The W2.0B-01B-01-02-03-00 active shaft weld is 550 mm long with a 20 mm diameter and 3.7 kg mass, serving as a driven welded shaft in the header conveyor.
Active drive data
| Part number | W2.0B-01B-01-02-03-00 |
| Component | Active shaft weld |
| Length | 550 mm |
| Diameter | 20 mm |
| Mass | 3.7 kg |
| System | Header conveyor |
Active shaft weld role
The active shaft transfers rotational motion to the connected header component and keeps the driven parts located along its 20 mm shaft body.
Active shaft weld differences
Unlike the long middle and frame shaft welds, this shorter active shaft is focused on the drive connection rather than spanning a wide structural section.
Active shaft weld installation
Inspect the drive connection and machined diameter before installation. Align the shaft with the drive point first, then seat the supports without forcing the assembly.
Check end float and surrounding guards after fitting, and verify that the drive component turns without binding.
Active shaft weld wear checks
- Damaged drive connection
- Worn shaft surface
- Bent 550 mm body
- Loose support
- Cracked welded feature
- Noise from poor alignment
Active shaft weld ordering checks
Active header drive position, W2.0B application.
Quote W2.0B-01B-01-02-03-00 and check the 550 mm length, 20 mm diameter and 3.7 kg mass.
Compare the drive feature, support seats, diameter and length with the original part.
Active shaft weld related parts
Active shaft weld questions
Does the listing include a bearing?
No bearing is identified in the source data, so it should not be assumed to be included.
What indicates a bent active shaft?
Binding, uneven rotation or vibration during operation can point to shaft distortion.
Identification of W2.0B-01B-01-02-03-00 before ordering
Select this active shaft weld when the drive shaft is bent, worn or has a damaged welded connection.




