Piston 4G33TC-050001A for FM WORLD 6.0P
This is an engine piston for the 4G33TC engine in the FM WORLD 4LZ-6.0P, diameter 95 mm, piston pin bore 32 mm, height 87 mm, weight 0.81 kg. It moves inside the cylinder and transfers the firing force through the piston pin.
Specifications
| Part number | 4G33TC-050001A |
|---|---|
| Type | Engine piston |
| Diameter | 95 mm |
| Pin bore | 32 mm |
| Height | 87 mm |
| Weight | 0.81 kg |
| Fits | FM WORLD 4LZ-6.0P (Ruilong), 4G33TC engine |
| Availability | in stock, ready to ship |
What this part does
The piston crown receives the pressure of combustion and drives the connecting rod, while the ring grooves carry the compression and oil rings and the pin bore takes the piston pin. Pistons are directional: a front mark or arrow must point the correct way so the ring gaps, pin offset, and combustion chamber line up with the engine. The piston is slightly smaller than the 100 mm bore to leave the controlled clearance the engine needs.
Piston against the ring kit
The piston is the body that carries the load; the rings and pin are separate parts fitted into it. A new piston is only correct if its grooves and pin bore match the rings and pin used for this engine.
Fitting notes
Note the orientation mark before fitting, install the rings in their grooves with the correct orientation, and use a ring compressor to enter the cylinder square. Lubricate the piston and rings with clean engine oil and fit the pin by the method in the service manual.
Before you fit it
Check the ring grooves and pin bore for wear or damage on the old assembly and confirm the cylinder is in suitable condition. A new piston will not seal in a worn or tapered liner.
Signs this part needs replacing
- Burned or melted crown from overheating or injection faults
- Scuffed or scored skirt leading to piston seizure
- Damaged ring lands that no longer hold the rings
- Piston slap noise from excessive clearance or a worn skirt
Compatibility and cross-reference
Where it fits
Inside the 100 mm cylinder of the 4G33TC engine in the FM WORLD 4LZ-6.0P, joined to the connecting rod.
Confirming the correct part
Confirm by part number 4G33TC-050001A, the 95 mm diameter, and the 32 mm pin bore that matches the piston pin.
Reading the old part
Measure the diameter, height, and pin bore and check the orientation mark. The 95 × 87 mm piston with a 32 mm bore identifies the part.
Frequently asked questions
Does the piston have a correct facing direction?
Yes. An arrow or front mark must point the specified way so the pin offset and chamber align. Fitting it backwards causes noise, oil use, and running faults.
Why is the piston 95 mm in a 100 mm bore?
The difference is the designed running clearance that lets the piston expand with heat and move on its oil film. The exact clearance is set by the engine design and service manual.





