,

Piston Ring Kit (4G33TC)

Piston Ring Kit (4G33TC). In stock for FM WORLD 4LZ-6.0P. Order by part number, contact us for fitment help.

Piston Ring Kit 4G33TC for FM WORLD 6.0P

This is the piston ring set for the 4G33TC engine in the FM WORLD 4LZ-6.0P, a 100 mm bore kit with three rings per piston: a top compression ring 2.5 mm wide, a second ring 5 mm wide, and an oil control ring 3 mm wide, weight 0.05 kg.

Specifications

Part number4G33TC
TypeThree-ring piston ring set
Top compression ring100 × 92 × 2.5 mm
Second ring100 × 92 × 5 mm
Oil control ring100 × 92 × 3 mm
Weight0.05 kg
FitsFM WORLD 4LZ-6.0P (Ruilong), 4G33TC engine
Availabilityin stock, ready to ship

What this part does

The rings do two jobs: the compression rings seal the firing pressure above the piston, and the oil control ring scrapes excess oil off the liner and returns it through the piston so it is not burned. Each ring is tensioned against the cylinder wall. They are not interchangeable between grooves, and most carry a mark that must face a specific direction, so fitting the wrong ring in the wrong groove causes oil use or lost compression.

Three rings, three different jobs

The top ring handles the highest heat and pressure, the second assists compression and oil control, and the oil ring is built to meter and return oil. Their widths and profiles differ, which is why each has its own groove and orientation.

Fitting notes

Use a ring expander rather than spreading the rings by hand, keep any marking facing the direction the manual states, and stagger the end gaps around the piston. Check the end gap in the cylinder before fitting, install the piston with a ring compressor, and follow the break-in procedure.

Before you fit it

Inspect the ring grooves for wear and the liner for the correct honed finish. New rings cannot seat in a worn groove or a glazed, tapered cylinder.

Signs this part needs replacing

  • Low compression and weak power from gas leaking past the rings
  • Blue or grey exhaust smoke and rising engine oil consumption
  • Blow-by gases and pressure in the crankcase
  • Rings stuck in their grooves from carbon buildup

Compatibility and cross-reference

Where it fits

Piston ring grooves in the 4G33TC engine of the FM WORLD 4LZ-6.0P, against the 100 mm cylinder wall.

Confirming the correct part

Confirm the 4G33TC engine and 100 mm bore, and match the three ring widths to the piston grooves before fitting.

Reading the old part

Identify each ring by its width and profile: 2.5, 5, and 3 mm for the top, second, and oil positions. The shared family part number does not distinguish them.

Frequently asked questions

Do the rings have a top and bottom?

Yes. Many rings carry a mark that must face upward, and the oil ring is assembled in a specific order. The service manual gives the orientation for each of the three rings.

Why must the end gaps be staggered?

Lining the gaps up creates a straight path for gas and oil to pass. Staggering them around the piston keeps compression sealed and oil controlled during the stroke.

Related parts