HST Plunger Assembly (40 Series) for FM WORLD 4LZ-6.0P Hydrostatic Drive
At 0.25 kg, this smaller 40-series plunger with a 35 mm upper and 45 mm lower diameter works in the cylinder block of the hydrostatic unit.
Smaller plunger dimensions
| Drawing number | WHST40-08-5B |
| Component | Plunger assembly |
| Reference dimensions | Upper 35 mm, lower 45 mm, height 17 mm |
| Set contents | 1 piece |
| Mass | 0.25 kg |
| Machine | FM WORLD 4LZ-6.0P (Ruilong) |
Reciprocating in the cylinder block
This plunger also slides in and out of its bore, turning the swash plate’s angle into oil flow that drives the hydrostatic motor.
40 versus 45 plunger
Compared with the 45-series plunger, this one has a smaller upper and lower diameter, so it only fits the 40-series unit.
Installing the smaller plunger
Lower the plunger into its bore without force, seat the slipper correctly, and cap the open housing until reassembly.
Cycle the transmission slowly and confirm smooth drive in both directions before returning to work.
Replacement warning signs
- Bore clearance enlarged with leakage
- Slipper surface worn or scratched
- Drive creeping from internal leak
- Contamination scoring the plunger
- Sticky movement after dirty oil
- Face pitting from metal debris
What to verify first
Mounting: Plunger assembly of the 40-series HST on FM WORLD 4LZ-6.0P (Ruilong).
Confirmation: Give the drawing number and note the 40-series dimensions and single piece.
Dimensions to match: Check the 35 mm upper and 45 mm lower diameter against the old plunger.
Related plunger and plates
Common buyer questions
Is it interchangeable with the 45 plunger?
No, the diameters differ and each fits its own series.
What mainly damages it?
Dirty oil with metal particles that score the plunger and bore.
Identification of WHST40-08-5B before ordering
Replace this plunger for leakage, a scored slipper or weak drive; assemble only with clean oil and the service manual procedure.





