HST Plunger Assembly (45 Series) for FM WORLD 4LZ-6.0P
This 45-series plunger assembly, 0.45 kg with a 90 mm outer face and 42 mm bore, reciprocates inside the hydrostatic pump to build the oil flow.
Plunger assembly data
| Drawing number | WHST45-08-4 |
| Component | Plunger assembly |
| Reference dimensions | Outer 90 mm, bore 42 mm, height 3 mm |
| Set contents | 1 piece |
| Mass | 0.45 kg |
| Machine | FM WORLD 4LZ-6.0P (Ruilong) |
Pumping oil inside the HST
As the cylinder block turns, the angled swash plate pushes this plunger in and out, drawing and forcing oil through the closed hydrostatic circuit.
45 versus 40 plunger
The 40-series plunger is smaller with a different bore, while this 45-series part is larger and the two cannot be swapped between units.
Fitting the larger plunger
Set the plunger into its clean bore, confirm the slipper seats on its plate, and keep every part washed and oiled before assembly.
After fitting, run the HST gently through its range and check the drive responds without noise or hesitation.
Wear that breaks its seal
- Plunger and bore worn with internal leakage
- Slipper face scored or pitted
- Loss of drive from oil leaking past
- Metal particles in the oil
- Plunger sticking in the bore
- Hardened or damaged sealing face
Ordering checks
Mounting: Plunger assembly of the 45-series HST on FM WORLD 4LZ-6.0P (Ruilong).
Confirmation: Quote the drawing number and confirm the 45-series size and single-piece set.
Dimensions to match: Match the 90 mm outer face and 42 mm bore to the plunger being removed.
Plunger and plate parts
Buyer questions
What moves the plunger?
The angled swash plate makes it reciprocate as the block rotates.
Why would the HST lose drive?
A worn plunger lets oil leak past inside, reducing the pressure that moves the machine.
Identification of WHST45-08-4 before ordering
Choose this plunger when the drive weakens, oil leaks internally or the face is scored; cleanliness is essential, so follow the service manual.




