What is the Transmission Input Shaft?
The DV01402010067 page describes a Lovol transmission input shaft using a stored real-part record. The number is the confirmed ordering reference; the shaft geometry itself must still be compared with the removed part because the extracted catalogues list input shaft sections without this exact line.
Evidence and ordering facts
| Part Number | DV01402010067 |
|---|---|
| Part Type | Transmission Input Shaft |
| Brand | Lovol |
| Machine System | Transmission Input Drive |
| Evidence Source | Archived Lovol part record for DV01402010067 |
| Evidence Boundary | The extracted RG catalogue text shows input shaft sections but no exact DV01402010067 row |
| Ordering Check | Compare spline count, journal and seal area on the removed shaft before ordering |
Role in the transmission input drive
This shaft carries rotating power from the clutch side into the transmission so the gear sets can change speed and torque for travel and working loads. It turns only while the drive path is engaged, so any runout, worn spline or loose bearing support shows up as noise or vibration that follows engine speed rather than travel speed.
Wear and fault symptoms
Typical complaints are a rattle or whine from the gearbox that grows under load, vibration through the machine frame, oil weeping at the input seal, difficulty selecting a gear, or metallic particles found when the transmission oil is drained. A worn clutch, a failing bearing or low oil level can produce similar symptoms, so the shaft should not be blamed before those paths are checked.
Fitment and ordering check
Hold DV01402010067 against the removed shaft and compare the spline section, the bearing journals, the seal contact surface and the overall length. Damage concentrated at the spline usually points to misalignment or a worn mating part, while scoring at a journal points to bearing failure and lubrication loss.
Repair planning notes
Plan the repair with the transmission drained and the drive path isolated according to the service procedure. Inspect the mating spline, bearing seats and seal bore before fitting a new shaft, because a damaged bore will destroy the replacement in a short time. Refill with the specified oil, check for leaks at the input area, then run the machine unloaded and listen for the previous noise before returning to field work.
Return to the HST and hydraulic drive category for the rest of the hydrostatic drive group, then compare these linked transmission parts: External Friction Plate – DV01402010096, HST Hydrostatic Transmission 50cc.





