,

Grain Unloading Auger A (W2.5B-04BX-04-01-00)

grain unloading auger A. In-stock replacement for the FM WORLD harvester. Order by part number; contact us for exact fitment.

Grain Unloading Auger A W2.5B-04BX-04-01-00 — 13.4 kg

Standing at the head of the 4.0E unloading train, this 13.4 kg weldment is the A section that begins the discharge on the FM WORLD 4LZ-4.0E. From its position at the tank outlet it sets the grain moving, then hands it to the middle short auger and the sections beyond so the tank can be emptied without grain lodging in the path.

Specifications

Part numberW2.5B-04BX-04-01-00
TypeGrain unloading auger A section
Weight13.4 kg
FitsFM WORLD 4LZ-4.0E Combine Harvester
AvailabilityIn stock, ready to ship

What this auger does

During discharge the A section carries a heavy stream of grain, and over time its flight edge wears while the tube gap widens, which cuts the rate at which the tank empties. Because it is the first section, its flight also establishes the timing that every following section must match, so a worn or mistimed A section is felt along the entire train.

The 4.0E A unloading auger against the 6.0P B section

This 1879 A section is built for the 4.0E unloading frame at 13.4 kg, while the 2428 B section is a 1735 mm, 60 mm-shaft part for the 6.0P. The frames and mount positions differ, so the two are not interchangeable.

Fitting notes

Brush the tube and seats clean, offer the A section in with slack mounts, and set its flight timing against the middle short section before locking anything. Work the complete unloader through hand rotations; the joint should run at a steady gap without a snag. Once the mounts are secured and the bearings oiled, verify the turning sense carries grain toward the outlet.

Before you fit it

Look at the middle short auger and the discharge sections, since the timed train performs as a single unit.

Signs it needs replacing

  • Slower tank emptying from a worn flight edge
  • Grain catching at the joint through lost timing
  • A bent section rubbing the tube
  • Bearing or journal wear at the mounts

Compatibility and cross reference

Models covered

Fits the FM WORLD 4LZ-4.0E unloading train at the A position; verify the number and the A mount before ordering.

Confirming the right part

Match W2.5B-04BX-04-01-00 and the A position. Confirm dimensions against the removed part where source data is absent.

Reading the old part

The listing gives weight rather than dimensions — 13.4 kg — which is why this section is best identified by its mounting pattern and its place in the unloading sequence rather than by the tape. Weigh it if the number is gone; a section that has been welded on will read heavier.

Questions we are asked about this auger

Does the first unloading section need timing to the others?

Yes. The A section sets the flight timing for the train, so fit and time it to the service manual; an untimed joint lets grain catch and slows discharge.

Related parts