,

Grain Unloading Auger Weld (W3.5-04HX-11-01-00)

grain unloading auger weld. In-stock replacement for the FM WORLD harvester. Order by part number; contact us for exact fitment.

Grain Unloading Auger W3.5-04HX-11-01-00 — 1685 mm, 11.25 kg

Distinguished by its stepped journals, this 11.25 kg weldment is a main discharge section on the FM WORLD 4LZ-6.0P Ruilong. The 1685 mm tube runs 140 mm wide, with a 40 mm main journal stepping down to 22.5 mm at the ends, and the long helix makes it one of the high-volume sections that keeps the unloading train moving.

Specifications

Part numberW3.5-04HX-11-01-00
TypeGrain unloading auger weld
Length x width1685 x 140 mm
Journal (main / ends)40 mm / 22.5 mm
Weight11.25 kg
FitsFM WORLD 4LZ-6.0P (Ruilong) Combine Harvester
AvailabilityIn stock, ready to ship

What this auger does

At the high speeds of discharge the helix outer edge takes the brunt of the grain, and the tube gap opens as that edge wears, so the tank empties more slowly. The stepped 22.5/40 mm journals give a sure way to confirm the part, and the rigid weld is supplied as a whole section rather than as a replacement helix.

The unloading auger against the tank lifting augers

This section pushes grain horizontally toward the discharge opening at the tank outlet, while the 2433 and 2507 augers lift grain upward into the tank. The mount orientation and journal layout differ, so an unloading section cannot be used as a lift and vice versa.

Fitting notes

Brush the tube and bearing bores clean, then offer the weldment in with slack mounts and work it through hand rotations, watching the helix hold a steady gap across the 1685 mm span before locking it. On reconnecting the drive, check the turning sense carries grain toward the discharge. Where this section joins a timed unloader, set its flight against the neighbour per the manual, and oil the bearings to the schedule.

Before you fit it

Look at the tube and the adjacent section, since the timed train runs as one unit.

Signs it needs replacing

  • Slower tank emptying as the flight edge wears
  • Enlarged tube clearance from a worn outer edge
  • Grain catching at a joint from flight timing
  • Bearing or stepped-journal wear causing noise

Compatibility and cross reference

Models covered

Fits the FM WORLD 4LZ-6.0P Ruilong unloading train; verify the 1685 mm tube and the stepped journals.

Confirming the right part

Match W3.5-04HX-11-01-00 and the 22.5/40 mm journals. Confirm discharge orientation and timing.

Reading the old part

1685 x 140 mm with a 40 mm main journal and 22.5 mm end journals, 11.25 kg. The stepped journal is the giveaway: a shaft with one journal size along its whole length is not this part, whatever its length says.

Questions we are asked about this auger

The auger turns but the tank empties slowly. What is worn?

Usually the flight outer edge, which opens the tube clearance and moves less grain per turn. Check the edge and the joint timing, and confirm the rotation drives grain to the outlet.

Related parts