,

Bearing 6008-RS

6008-RS single-row deep groove ball bearing, rubber sealed. 40 mm bore, 68 mm outside diameter, 15 mm width, 0.20 kg. Replacement for the FM WORLD 4LZ-4.0E / 4LZ-6.0P (Ruilong) combine harvester. In stock, ready to ship.

Bearing 6008-RS — 40 x 68 x 15 mm for FM WORLD 4LZ-4.0E / 4LZ-6.0P (Ruilong)

The 6008-RS measures 40 mm bore by 68 mm outside diameter by 15 mm width, which makes it a thin-section bearing for a 40 mm shaft. It is the sealed version used on the FM WORLD 4LZ-4.0E and 4LZ-6.0P where the housing is narrow and the load is light.

Specifications

Part number6008-RS
Typesingle-row deep groove ball bearing, rubber sealed
Bore diameter40 mm
Outside diameter68 mm
Width15 mm
Weight0.20 kg
FitsFM WORLD 4LZ-4.0E / 4LZ-6.0P (Ruilong)
AvailabilityIn stock, ready to ship

Bearing type and load capacity

The 60 series is the lightest of the three common deep groove families: same bore, smaller outside diameter and narrower width than 62 or 63. That suits positions where space is tight and the load is modest, and it keeps friction low at high shaft speed.

6008-RS against 6008-2RS

Both are 40 x 68 x 15 mm. The difference is how the sealing is described: 2RS always means a seal on each side, while RS is written differently by different makers and can be a single seal or a pair. Count the seals on the part you are replacing before ordering, and tell us if yours has only one.

Fitting notes

Check that the seal faces outward and that the housing shoulder does not press on the seal lip. A pinched lip lets abrasive dust straight into the raceway.

Before you fit it

Shaft and housing

A 40 mm journal with a shallow 15 mm ring leaves little material to absorb a bad fit. Check the journal for a polished step and make sure the 68 mm bore is clean before the bearing goes on.

Signs it needs replacing

  • A dry rasping sound rather than a smooth hum
  • Dust or grease built up on one side of the seal
  • Rough rotation felt by turning the inner ring by hand
  • A worn or polished ring where the seal sits on the shaft

Compatibility and cross reference

Models covered

Both the 4LZ-4.0E and the 4LZ-6.0P take this number, which makes it a useful line to hold for either machine.

Confirming the right part

Tell us how many seals your old part has and what the 68 mm bore measures, and we will say whether RS or 2RS is the right choice.

Questions we are asked about this bearing

Can I run it with one seal removed?

Only if the open side faces a sealed, oil-filled housing. In a dusty combine bay the open side will not survive.

Related parts