,

Bearing 6002-2RS

6002-2RS single-row deep groove ball bearing, rubber sealed on both sides. 15 mm bore, 32 mm outside diameter, 9 mm width, 0.03 kg. Replacement for the FM WORLD 4LZ-4.0E / 4LZ-6.0P (Ruilong) combine harvester. In stock, ready to ship.

Bearing 6002-2RS — 15 x 32 x 9 mm for FM WORLD 4LZ-4.0E / 4LZ-6.0P (Ruilong)

The 6002-2RS is the smallest bearing in this group at 15 x 32 x 9 mm and 0.03 kg. It seals both sides and greases for life, which suits small lightweight mechanisms on the FM WORLD 4LZ-4.0E and 4LZ-6.0P.

Specifications

Part number6002-2RS
Typesingle-row deep groove ball bearing, rubber sealed on both sides
Bore diameter15 mm
Outside diameter32 mm
Width9 mm
Weight0.03 kg
FitsFM WORLD 4LZ-4.0E / 4LZ-6.0P (Ruilong)
AvailabilityIn stock, ready to ship

Bearing type and load capacity

A 15 mm bore in the 60 series gives a 32 mm outside diameter, so this part is used on small shafts and light mechanisms rather than drive lines. Its capacity is small by design, and it should never be used to upgrade a position that needs a larger bearing.

6002 against 6202 on a 15 mm shaft

The 6202 is 15 x 35 x 11 mm. It shares the bore but has a larger outside diameter and more width, and with them more load capacity. If the housing will take 35 mm and the load justifies it, the 6202 is the stronger part. Note that the 6302 is not comparable: its bore is 17 mm.

Fitting notes

Handle with clean gloves and keep the seals intact. At this size a single grain of abrasive under the seal is enough to start a wear track.

Before you fit it

Shaft and housing

At 0.03 kg this part distorts easily. Keep the 32 mm bore clean, use a sleeve on the 15 mm journal, and never drive it in by the outer ring.

Signs it needs replacing

  • Squeak at low speed that disappears at high speed
  • Seal lip lifted or packed with fine dust
  • Notchy rotation when turned slowly by hand
  • Corrosion spotting on the outer ring

Compatibility and cross reference

Models covered

The smallest bearing in this range, supplied for both the 4LZ-4.0E and the 4LZ-6.0P.

Confirming the right part

Check the 32 mm bore against the number on the old bearing. A 35 mm bore belongs to a 6202, the next size up on this shaft.

Questions we are asked about this bearing

Is the 6002 the same as a 6302?

No. The 6002 has a 15 mm bore, 32 mm outside diameter and 9 mm width; the 6302 has a 17 mm bore, 42 mm outside diameter and 13 mm width.

Related parts