,

Bearing 6007-2RS

6007-2RS single-row deep groove ball bearing, rubber sealed on both sides. 35 mm bore, 62 mm outside diameter, 14 mm width, 0.15 kg. Replacement for the FM WORLD 4LZ-6.0P (Ruilong) combine harvester. In stock, ready to ship.

Bearing 6007-2RS — 35 x 62 x 14 mm for FM WORLD 4LZ-6.0P (Ruilong)

The 6007-2RS is a 35 mm-bore thin-section bearing, 62 mm outside diameter and 14 mm wide, sealed both sides. It fits positions on the FM WORLD 4LZ-6.0P where a 35 mm shaft runs in a narrow housing.

Specifications

Part number6007-2RS
Typesingle-row deep groove ball bearing, rubber sealed on both sides
Bore diameter35 mm
Outside diameter62 mm
Width14 mm
Weight0.15 kg
FitsFM WORLD 4LZ-6.0P (Ruilong)
AvailabilityIn stock, ready to ship

Bearing type and load capacity

In the 60 series a 35 mm shaft needs only a 62 mm housing bore, which is the same outside diameter as a 25 mm-bore 6305. That is the point of the thin-section family: it saves room, and it is the reason the number alone tells you nothing about capacity.

One 35 mm bore in three sections: 6007, 6207 and 6307

The 6007 is 35 x 62 x 14 mm, the 6207 is 35 x 72 x 17 mm and the 6307 is 35 x 80 x 21 mm. Same shaft, three housing bores of 62, 72 and 80 mm. This bearing suits the 62 mm bore; using a 6207 in its place will not fit, and forcing the issue damages the housing.

Fitting notes

Because the rings are thin, support the outer ring squarely and avoid any side load during assembly. A cocked thin ring will run hot even at moderate speed.

Before you fit it

Shaft and housing

Thin rings only 14 mm wide need a square seat. Check the 62 mm bore for out-of-round and the 35 mm journal for a polished band.

Signs it needs replacing

  • A soft continuous rumble rather than a sharp knock
  • Seal ring loose in its groove
  • Even, glassy polishing of the raceway
  • Light rust on the outside diameter after a wet season

Compatibility and cross reference

Models covered

This number is listed for the 4LZ-6.0P, where a 35 mm shaft runs in a narrow housing.

Confirming the right part

The 62 mm bore tells you this is the 6007 rather than the 6207 at 72 mm or the 6307 at 80 mm on the same 35 mm shaft.

Questions we are asked about this bearing

Can I use a 6207 where a 6007 was fitted?

No. The housing bore for a 6007 is 62 mm and a 6207 needs 72 mm. The bore decides the part.

Related parts