6202-2RS Rubber-Sealed Ball Bearing for FM WORLD 4LZ-6.0P
With a 15 mm bore, 35 mm outer ring and 11 mm width, the 6202-2RS is a small sealed unit of 0.04 kg for the FM WORLD 4LZ-6.0P. Its 2RS ending places a nitrile rubber seal on each side.
6202-2RS dimensions
| Part number | 6202-2RS |
| Construction | Single-row sealed ball bearing |
| Bore | 15 mm |
| Outer ring | 35 mm |
| Width | 11 mm |
| Weight | 0.04 kg |
| Seals | Nitrile rubber, one each side |
| Fits | FM WORLD 4LZ-6.0P Ruilong combine |
Inside the sealed 62-series ring
The 62 medium series is the general-purpose proportion, and the 02 bore code gives the 15 mm journal. The two contact seals hold the factory grease inside and block dust and moisture, so the ring is greased for life. Washing it in solvent or prying the seals open only damages them.
Built-in seals versus an external shaft seal
Because the contact seals travel with the ring, cleanliness does not depend on a separate shaft seal. If contamination still appears, inspect the housing rather than removing the bearing’s own seals.
Mounting a sealed unit
Apply force through the inner ring with a flat driver and keep pressure away from the rubber. Wipe the journal and bore first, since a sealed ring cannot flush out grit after assembly.
Check the journal is smooth where it meets the seal and leave the wrapper on until the last moment. The whole unit is exchanged once worn rather than re-packed.
Replacement symptoms
- Rough running as the life grease ages
- Slack between the rings after the track spalls
- A torn or displaced rubber seal
- Heat and vibration from dried lubricant
- Rumbling that rises with rotational speed
- Pitting found when the ring is removed
How to order
Mounting: Pressed onto a 15 mm journal, the rubber pair closing each face.
Verify: Verify number 6202-2RS and the 15 / 35 / 11 mm measurements.
Dimensions to match: Check bore and outer ring and confirm both rubber seals are intact.
Other bearings in this range
Questions answered
What does 2RS add to a 6202?
A rubber contact seal on each side retains the factory grease and excludes dust and water, so the unit is greased for life.
May the seals be lifted to add grease?
No. Opening them breaks the seal and exposes the track; a noisy 2RS ring is simply exchanged.
6202-2RS identification before ordering
Note the stamped number and check the bore, outer ring and width. A worn marking is no problem: send the number and a photo and the sealed unit will be matched.





