6205-2RS Rubber-Sealed Ball Bearing for FM WORLD 4LZ-6.0P
The 6205-2RS steps up to a 25 mm bore, 52 mm outer ring and 15 mm width, weighing 0.15 kg on the FM WORLD 4LZ-6.0P. Two rubber seals, indicated by 2RS, close both faces.
Measured 6205-2RS data
| Part number | 6205-2RS |
| Type | Single-row deep groove ball, sealed |
| Bore | 25 mm |
| Outer ring | 52 mm |
| Width | 15 mm |
| Weight | 0.15 kg |
| Sealing | Pair of 2RS rubber seals |
| Fits | FM WORLD 4LZ-6.0P (Ruilong) |
What the larger ring carries
Another 62 medium-series ring, the 05 bore code raises the journal to 25 mm and every dimension grows in proportion. Balls travel in deep matching grooves that take radial load and some axial load, while the rubber pair keeps the grease clean throughout the unit’s life.
Wear versus a lubrication problem
A sealed ring cannot be under-greased in service, so heat or noise points to wear or a poor fit rather than a missed lubrication. Check housing alignment and the journal before fitting a replacement.
Seating the bearing
Press on the inner ring only, square to the shaft, and never let the driver touch the rubber. The seat and journal must be clean and within the service manual tolerances.
Inspect the journal at the seal line for wear and leave the ring sealed until assembly. A unit that has run hot is exchanged rather than re-packed.
When to change it
- Noise or roughness once the raceway spalls
- Excess slack between inner and outer rings
- A split or shifted rubber seal
- Heat and vibration from aged lubricant
- Flaking metal found on track or balls
- A rough turn that follows shaft speed
Fit and ordering
Mounting: Fitted over a 25 mm journal, seals on both faces.
Verify: Verify number 6205-2RS and the 25 / 52 / 15 mm measurements.
Dimensions to match: Check bore and outer ring and inspect both seals before assembly.
Related parts
FAQ
How does 6205-2RS differ from 6202?
Both are sealed 62-series rings, but the 05 code gives a 25 mm bore and larger 52 mm ring for a heavier journal.
Is periodic greasing required?
No. The 2RS seals keep the factory grease for life; opening them breaks the seal, so a worn unit is exchanged whole.
6205-2RS identification before ordering
Record the stamped number and measure the three dimensions. If it cannot be read, a number and photo through the quote form will identify the correct sealed ring.




