6301-2RS Heavy-Series Sealed Ball Bearing for FM WORLD 4LZ-6.0P
A 12 mm bore, 37 mm outer ring and 12 mm width make the 6301-2RS a compact but heavy-section sealed unit of 0.05 kg for the FM WORLD 4LZ-6.0P. The 2RS ending again provides two rubber seals.
6301-2RS specification
| Part number | 6301-2RS |
| Construction | Sealed single-row deep groove ball |
| Bore | 12 mm |
| Outer ring | 37 mm |
| Width | 12 mm |
| Weight | 0.05 kg |
| Seals | Two nitrile rubber, 2RS |
| Fits | FM WORLD 4LZ-6.0P Ruilong |
Why the heavy 63 series is used
The 63 heavy series pairs a small 01-coded 12 mm bore with a comparatively large 37 mm ring and wider 12 mm section to carry greater load. The deep groove and caged balls still accept radial and axial force, while the two seals retain grease and keep the track clean for life.
Series choice matters on a small bore
The 63 series is chosen for high load in a small bore, so fitting a slimmer 62-series ring risks early failure. Match the number and outer ring rather than only the bore.
Installation points
Drive through the inner ring with a flat sleeve, square to the shaft, and keep the tool off the rubber. Clean the journal and housing and confirm the fits to the manual first.
Since the seals retain the grease, never wash or open the ring, and keep it wrapped until assembly. It is exchanged complete once worn.
Failure indicators
- Rumbling as the heavier-loaded track spalls
- Slack or roughness while turning the shaft
- A damaged seal that admits grit
- Heat from a worn or misaligned fit
- Vibration felt through the housing
- Pitting on the balls or raceways
Ordering information
Mounting: Driven onto a 12 mm journal with its two rubber seals.
Verify: Verify number 6301-2RS and the 12 / 37 / 12 mm measurements.
Dimensions to match: Check bore and the larger outer ring and confirm the seals are intact.
Companion bearings
Brief answers
Why choose 6301 over 6201 on the same bore?
The heavy 63 series gives a larger ring and wider section for a 12 mm bore, carrying greater load where space allows.
Is it re-lubricated?
No. It is sealed and greased for life, so the seals stay intact and a worn ring is exchanged whole.
6301-2RS identification before ordering
Read the etched number and measure bore, ring and width. When the marking is worn, send the number and a photo and the heavy sealed unit will be confirmed.





