,

Bearing 6306-2RS

6306-2RS single-row deep groove ball bearing, rubber sealed on both sides. 30 mm bore, 72 mm outside diameter, 19 mm width, 0.34 kg. Replacement for the FM WORLD 4LZ-6.0P (Ruilong) combine harvester. In stock, ready to ship.

Bearing 6306-2RS — 30 x 72 x 19 mm for FM WORLD 4LZ-6.0P (Ruilong)

The 6306-2RS pairs a small 30 mm bore with a 72 mm outside diameter and 19 mm width. That is a heavy-section bearing for its shaft size, which is exactly what is wanted where a compact shaft takes shock load on the FM WORLD 4LZ-6.0P.

Specifications

Part number6306-2RS
Typesingle-row deep groove ball bearing, rubber sealed on both sides
Bore diameter30 mm
Outside diameter72 mm
Width19 mm
Weight0.34 kg
FitsFM WORLD 4LZ-6.0P (Ruilong)
AvailabilityIn stock, ready to ship

Bearing type and load capacity

In the 63 series the wall thickness and ball size are increased for the same bore, so radial capacity climbs well above the 62 series. On a combine the payoff is resistance to the repeated impact of cutterbar and threshing loads rather than high steady speed.

6306-2RS against the 6206 with the same 30 mm bore

The 6206 is 30 x 62 x 16 mm. Going to the 6306 adds 10 mm of outside diameter and 3 mm of width, and with it a clear step up in radial load rating. If the housing bore is 62 mm the 6206 is the only fit; if it is 72 mm the 6306 is the stronger part.

Fitting notes

Warm the bearing to about 80 C in clean oil before a tight fit, never hammer it cold onto the shaft. A distorted ring will run hot from the first minute.

Before you fit it

Shaft and housing

A 30 mm shaft carrying a 72 mm ring means the housing holds most of the mass. Look for fretting in the bore and a bright wear band on the shaft.

Signs it needs replacing

  • Rumble that is loudest under load and quiet when unloaded
  • Seal lip pushed out or torn on the loaded side
  • Local pitting or a dull grey band on the raceway
  • Grease thrown out in a ring around the housing

Compatibility and cross reference

Models covered

The 4LZ-6.0P uses this number. It is not listed for the 4LZ-4.0E, so check the machine model before ordering.

Confirming the right part

Check the 72 mm bore and the number on the old ring. A 62 mm bore takes a 6206, which is the lighter part on this same 30 mm shaft.

Questions we are asked about this bearing

Is this the same as a 6306 open bearing?

Same 30 x 72 x 19 mm envelope, but this one is sealed on both sides and greased for life. An open 6306 needs a separate lubrication supply.

Related parts