Bearing 6012-2RS — 60 x 95 x 18 mm for FM WORLD 4LZ-4.0E Combine Harvester
The 6012-2RS takes a large 60 mm shaft but keeps a slim 95 mm outside diameter and an 18 mm width. On the FM WORLD 4LZ-4.0E it is used on a big shaft that turns freely and fast rather than one carrying the heaviest shock, and the double seals remove the need for a lubrication point.
Specifications
| Part number | 6012-2RS |
|---|---|
| Type | single-row deep groove ball bearing, rubber sealed on both sides |
| Bore diameter | 60 mm |
| Outside diameter | 95 mm |
| Width | 18 mm |
| Weight | 0.38 kg |
| Fits | FM WORLD 4LZ-4.0E Combine Harvester |
| Availability | In stock, ready to ship |
Bearing type and load capacity
A 60 series bearing on a 60 mm journal is a deliberate pairing: the thin section keeps friction low at high speed and leaves room around a large shaft, while the load rating stays modest. It is built for free-running large shafts, and fitting it onto a heavily impacted drive would misuse that design.
6012-2RS against the 6210 on the nearby 50 mm drive
The 6210 serves a 50 mm shaft at 90 mm outside diameter, so the two are not interchangeable and illustrate different choices: the 6210 carries a medium load on a smaller journal, while the 6012 runs a larger 60 mm shaft at light load in a slim ring. Pick the part by the journal size first, then by the load, never by the outside diameter alone.
Fitting notes
On a 60 mm bore the ring is large but the section is thin, so heat it for the fit and avoid any side load. Forcing the slim ring cold is the usual cause of a 6012 that runs hot from new.
Before you fit it
Shaft and housing
Check the large journal for deflection and the seal seat for a wear step. The slim ring relies on a true 60 mm shaft to keep the seal lip seated.
Signs it needs replacing
- Smooth hum that turns rough only at high speed
- Light rust spotting on the outer ring after wet work
- A glassy, polished raceway rather than pitting
- Seal wear where the large shaft deflects under load
Compatibility and cross reference
Models covered
The sealed 6012 is listed for free-running 60 mm shafts on the FM WORLD 4LZ-4.0E.
Confirming the right part
Use the old number to order and confirm the 60 mm journal together with the 95 mm bore. The bore and journal together identify the 6012.
Questions we are asked about this part
Why use a thin 60 series bearing on such a large shaft?
Because the position is fast and lightly loaded. The 6012 keeps friction and space down on a 60 mm shaft; a heavy 6312 would add bulk the housing and the load do not call for.





