,

Middle Short Auger Weld (W2.5B-04BX-03-03-00)

middle short unloading auger weld. In-stock replacement for the FM WORLD harvester. Order by part number; contact us for exact fitment.

Middle Short Auger W2.5B-04BX-03-03-00 — 2.95 kg

This is the short middle auger in the grain unloading path on the FM WORLD 4LZ-4.0E. It is a compact weldment weighing 2.95 kg that bridges two longer unloading sections, keeping grain moving through the joint rather than leaving a dead zone where material could settle. Because it is short it turns at the junction of the unloading system and is driven in time with the augers either side of it.

Specifications

Part numberW2.5B-04BX-03-03-00
TypeMiddle short unloading auger
Weight2.95 kg
FitsFM WORLD 4LZ-4.0E Combine Harvester
AvailabilityIn stock, ready to ship

What this auger does

As a short transfer section, this auger’s job is to hand grain across the junction without a gap. Its flight edge still wears from the abrasive grain, and a worn or misaligned middle section is a common cause of grain hanging up at the unloading joint rather than flowing smoothly. The short, rigid weld is replaced as a unit.

The middle short auger against the full unloading augers

This is a short bridging piece at a junction, whereas the 1879 and 2428 unloading augers are long full-length sections that do the main conveying. It cannot replace a long section and is only fitted at the middle position it is designed for.

Fitting notes

Brush out the junction seats and offer the short weldment in so its helix meets the neighbouring flights, keeping the mounts slack while the drive is timed. Once the connected unloading train is worked through by hand, the joint should pass grain without a single snag, and only then are the mounts tightened and the bearings oiled. Because the flights across a multi-section unloader must be timed, work to the manual’s timing procedure rather than seating the piece at a random angle.

Before you fit it

Check the long unloading augers either side, since a worn neighbour can cause the same junction blockage.

Signs it needs replacing

  • Grain hanging up or settling at the unloading junction
  • Worn flight edges on the short transfer section
  • Misaligned flight timing at the joint
  • Bearing or journal wear at the junction seat

Compatibility and cross reference

Models covered

Listed for the FM WORLD 4LZ-4.0E unloading system; confirm the part number and the middle position before ordering.

Confirming the right part

Match W2.5B-04BX-03-03-00. This is the short middle section; dimensions should be confirmed against the removed part.

Reading the old part

The middle short auger is listed by weight, 2.95 kg, with no length in the table. That makes it the hardest one of the family to identify on sight, so compare it against the section it came out of and keep the old part on the bench until the new one is fitted.

Questions we are asked about this auger

Grain keeps catching at one point during unloading. What should I check?

The short middle auger at that junction may be worn or out of timing with the long sections. Check the flight edges and re-time the joint to the service manual.

Related parts