Grain Unloading Belt Tensioner Arm (300 mm) for FM WORLD 4LZ-6.0P
On the unloading circuit, this 300 x 80 x 90 mm arm at 1.05 kg holds the idler against the belt that empties the grain tank and elevator.
Size of the arm
| Part number | W2.5B-04CM-02-02-01-00A |
| Part type | Unloading belt tensioner arm |
| Overall size | 300 x 80 x 90 mm |
| Weight | 1.05 kg |
| Fits | FM WORLD 4LZ-6.0P (Ruilong) |
Keeping the emptying belt loaded
Emptying only runs smoothly while the belt stays loaded; the arm presses the idler on that belt so the grain keeps moving through the auger and elevator without slowing or plugging.
How it differs from the sieve arm
This is a grain-tank part, not a sieve or threshing lever, and the 300 x 90 mm shape plus its part number identify it. The sieve arm is a separate, lighter lever.
Bolting the arm on
Bolt the arm to its pivot and move it through its range by hand, then attach the idler and load the belt.
Work the unloading cycle and confirm the arm stays put and the idler tracks the belt, with no give under the pull.
Reasons to renew it
- Loose pivot faces
- Welds that have opened
- A crooked arm throwing the idler off
- Belt slipping while the tank empties
- Noise at the mounting
- Rust across the plate
Before you order
Mounting: Grain-tank unloading belt of FM WORLD 4LZ-6.0P (Ruilong) harvesters.
Confirmation: Give us the part number with the 300 x 80 x 90 mm size and we check it is the unloading arm.
Dimensions to match: Measure the old arm, its pivot and the idler face and compare them with this part.
Arms on other circuits
Buyer questions
Will it fit the sieve drive?
No, the unloading circuit uses its own mountings and the arm is specific to it.
What belt does it press on?
The belt that carries grain out of the tank and through the elevator.
Identification of W2.5B-04CM-02-02-01-00A before ordering
Renew it only for a loose pivot, opened weld or crooked idler; a firm arm that keeps the belt loaded should stay.





