,

Tension Arm Weld (W2.5K-02HB-10-05-01-00)

Part W2.5K-02HB-10-05-01-00. In stock for FM WORLD 4LZ-6.0P. Order by part number, contact us for fitment help.

Threshing Tension Arm (52 mm Pivot) for FM WORLD 4LZ-6.0P

Built for the heavier threshing belt, this 265 x 195 x 45 mm lever weighs 1.1 kg and swings on a wide 52 mm pivot, 1.1 kg, to carry the idler under a high load.

Lever measurements

Drawing numberW2.5K-02HB-10-05-01-00
ComponentWelded threshing tension lever
Envelope265 x 195 x 45 mm
Pivot52 mm
Mass1.1 kg
MachineFM WORLD 4LZ-6.0P (Ruilong)

Holding the heavy belt

Where the header arm deals with a light belt, this one has to keep the idler pressed against the threshing drive while it pulls hard, so the welded plate and the wide pivot are built to resist that constant force.

Why the pivot is wide

The 52 mm pivot is the giveaway: the header lever turns on only 20 mm and could never fit this shaft. Reading the pivot size avoids mixing the two arms.

Dropping the lever on

Drop the greased lever over the wide pivot and bolt the idler on, then work it through the arc by hand to confirm the faces meet without a bind before the belt is loaded.

Once the belt is tensioned, run the threshing drive and watch the lever; it should sit steady with no rock or give where it meets the pivot.

Why it would be scrapped

  • The 52 mm pivot opening worn round
  • Plate welds opened under the heavy pull
  • A lever set off-square so the idler runs crooked
  • Belt throw or slip that the adjuster cannot take up
  • Rock felt at the pivot under load
  • Rust eating into the bore edge

Information for ordering

Mounting: Threshing belt tensioner of FM WORLD 4LZ-6.0P (Ruilong) harvesters.

Confirmation: Send the drawing number and the 52 mm pivot and we match the heavy lever.

Dimensions to match: Compare the envelope, pivot opening and idler face with the part removed.

Levers for other drives

  • Part 2334
  • Questions from buyers

    Will the header lever fit this pivot?

    It cannot; the 20 mm header part is far too small for the 52 mm shaft.

    Why is the pivot so wide?

    The threshing drive pulls harder than the header belt, and the wide pivot carries that load without wearing quickly.

    Identification of W2.5K-02HB-10-05-01-00 before ordering

    Order this lever only with a worn pivot, an opened weld or a crooked idler face; a steady lever that keeps the belt loaded should be kept.

    Request a Quote Now