Air-Conditioning Compressor W2.5-20K-60-07-01-00A (210 mm, 110 mm Diameter, 8 kg)
The W2.5-20K-60-07-01-00A compressor measures 210 x 110 mm in diameter and weighs 8 kg, serving as the pump in the cabin air-conditioning circuit.
Compressor data
| Part number | W2.5-20K-60-07-01-00A |
| Component | Air-conditioning compressor |
| Dimensions | 210 x 110 mm diameter |
| Mass | 8 kg |
| System | Cabin air conditioning |
| Action | Refrigerant compression |
Compressing the refrigerant
The compressor raises the pressure of the refrigerant and moves it through the air-conditioning circuit, allowing the evaporator to remove heat from cabin air.
Compressor and evaporator
The compressor is the pressure-generating pump. The evaporator is the heat-exchange assembly inside the cabin, and each has a separate role in the cooling circuit.
Installing the compressor
Before removal, release the drive load and disconnect the relevant lines and electrical connections following the service procedure. Mount the replacement with the correct pulley and bracket alignment.
Check the belt route and electrical connector after installation. Do not operate the compressor without a properly serviced refrigerant circuit.
Compressor failure symptoms
- Bearing noise from the pulley or compressor
- Clutch engagement failure
- Internal leakage reducing cooling pressure
- Loose mounting causing belt misalignment
- Damaged connector or wiring
- Seal failure at a line connection
What to verify before ordering
Mounting: Cabin air-conditioning compressor for the FM WORLD 4LZ-6.0P.
Confirmation: Use W2.5-20K-60-07-01-00A as the order reference and verify the 210 x 110 mm dimensions and 8 kg mass.
Dimensions to match: Match the pulley, mounting bracket, connector, line positions and part number before fitting.
Cabin air-conditioning parts
Compressor questions
Is the evaporator included with this compressor?
No. The compressor and evaporator are separate components in the same air-conditioning system.
Why does the compressor make noise?
Bearing wear, clutch problems, low system charge or mounting misalignment can produce abnormal noise.
Identification of W2.5-20K-60-07-01-00A before ordering
Replace this compressor after pressure and electrical checks indicate a compressor fault; a low refrigerant charge or wiring problem will not be solved by replacing the pump alone.





