,

Frame Assy,Header (W3.5D-01D-01-01C-00)

Part W3.5D-01D-01-01C-00. In stock for FM WORLD 4LZ-6.0P. Order by part number, contact us for fitment help.

Wide Header Frame (2580 mm) for FM WORLD 4LZ-6.0P

At 2580 mm this is the longer of the two header frames, 700 x 670 mm in section and 108 kg. The extra length supports the wider cutting table while still anchoring the knife, reel and cross auger.

Measurements of the long frame

Drawing numberW3.5D-01D-01-01C-00
ComponentWelded wide-header frame
Overall length2580 mm
Section700 x 670 mm
Mass108 kg
MachineFM WORLD 4LZ-6.0P (Ruilong)

Anchoring the wide table

Rather than doing work itself, the beam gives every header component a fixed reference point; the wider span has to stay true so the knife sections and reel tines line up from one side of the table to the other.

Long frame versus short frame

Length is the deciding factor: 2580 mm here against 2430 mm on the short frame. A short beam cannot reach the wide-table mountings, which is why the drawing number rather than a visual guess should be used.

Rigging the frame in place

Rig the beam to the feeder pivot and leave the bolts loose until the reel, knife and auger seats all line up, then tighten in stages. Check the long span for twist before loading it.

Once it is secure, square the table and turn each driven part by hand; a bind anywhere on the wide span usually traces back to a face sitting out of plane.

Why a frame would be scrapped

  • Welds that have opened following a hard impact
  • A beam that has taken a permanent twist
  • Pivot bores worn beyond a clean fit
  • A sag visible along the length
  • Mounted parts that jam even when fitted correctly
  • Section loss from rust at a high-stress point

Information for ordering

Mounting: Wide cutting table of FM WORLD 4LZ-6.0P (Ruilong) harvesters.

Confirmation: Send the drawing number with the 2580 mm measurement and tell us the cutting width, and we match the long beam.

Dimensions to match: Compare the length, section and pivot bores with the beam removed from the wide table.

Other frame and feeder parts

Questions from buyers

Will the short beam fit the wide table?

It will not; the mountings are spaced for the 2580 mm beam, so the shorter part cannot be substituted.

How is the correct frame picked?

Measure the old beam and the cutting width, then order against the drawing number; the 2580 mm part is the wide-table one.

Identification of W3.5D-01D-01-01C-00 before ordering

This long beam is ordered only after a collision, an opened weld or a twist; a true one that carries the table square should be left in service.

Request a Quote Now