Fuel Pump Timing Gear 4L88-040001A for FM WORLD 6.0P
This is the fuel injection pump timing gear for the engine in the FM WORLD 4LZ-6.0P, 56 teeth, 125 mm outer diameter, 50 mm bore, 20 mm wide, weight 0.8 kg. It drives the fuel injection pump and sets when fuel is delivered.
Specifications
| Part number | 4L88-040001A |
|---|---|
| Type | Fuel injection pump timing gear |
| Teeth | 56 |
| Outer diameter | 125 mm |
| Bore | 50 mm |
| Width | 20 mm |
| Weight | 0.8 kg |
| Fits | FM WORLD 4LZ-6.0P (Ruilong) |
| Availability | in stock, ready to ship |
What this part does
The gear turns the fuel injection pump in a fixed relationship to the crankshaft, so injection happens at the correct point in the piston’s travel. On a diesel engine the injection timing directly affects starting, power, smoke, and fuel use. The gear is keyed to the pump shaft, and the timing marks align it with the rest of the gear train during assembly.
Pump timing gear against the idler
Unlike the idler, this gear is attached to the pump and drives it, so its position changes the injection timing. It is not a free relay gear; misalignment here shifts when fuel is delivered.
Fitting notes
Align the timing marks before engaging the gear and fit it square onto the pump shaft with the key seated. Set the injection timing and backlash to the service manual procedure rather than adjusting by ear.
Before you fit it
Check the pump shaft and keyway and the meshing teeth for wear. A worn key or shaft lets the pump timing drift even when the gear is new.
Signs this part needs replacing
- Hard starting or rough running from shifted injection timing
- Black or white smoke and poor power from mistimed fuel delivery
- Worn teeth or a damaged keyway causing backlash
- Rattle from the pump drive at the front of the engine
Compatibility and cross-reference
Where it fits
Fuel injection pump shaft in the timing case of the FM WORLD 4LZ-6.0P engine.
Confirming the correct part
Confirm by part number 4L88-040001A, the 56 teeth, and the 50 mm bore for the pump shaft.
Reading the old part
Count the teeth and measure the bore and outer diameter. The 56-tooth, 125 mm pump gear identifies the part.
Frequently asked questions
Why is this gear’s timing important?
It determines when the injection pump delivers fuel relative to the piston. Correct timing is needed for clean starting, power, and low smoke.
Can it be fitted like the idler?
No. It is keyed to the pump and its marks set the injection timing, while the idler only relays motion on a fixed shaft.





