,

Grain Lifting Auger (W3.5H-02HA-10A-01-03-00)

small grain tank lifting auger. In-stock replacement for the FM WORLD harvester. Order by part number; contact us for exact fitment.

Grain Lifting Auger W3.5H-02HA-10A-01-03-00 — 1730 mm, 12 kg

This is the lifting auger for the small grain tank configuration on the FM WORLD 4LZ-6.0P Ruilong, measuring 1730 mm with a 130 mm flight and weighing 12 kg. It turns inside a matching shell and lifts grain up into the tank, the rotating counterpart to the dedicated auger shell that surrounds it.

Specifications

Part numberW3.5H-02HA-10A-01-03-00
TypeSmall grain tank lifting auger
Length x diameter1730 mm x 130 mm
Weight12 kg
FitsFM WORLD 4LZ-6.0P (Ruilong) Combine Harvester
AvailabilityIn stock, ready to ship

What this auger does

Like the other lift augers it works against gravity, so a worn flight edge opens the shell clearance and lets grain fall back, lowering the fill rate. The 130 mm flight sits between the 125 mm cleaning elevator and the 162 mm tank lift, and is specific to the small tank shell it runs in.

The 130 mm small-tank auger against the similar 2500 auger

This 2507 auger is 1730 mm for the 10A shell, while the closely related 2500 auger is 1680 mm for a different shell. They look alike and share a 130 mm flight, but the length and shell differ, so the part number must be matched rather than assuming the two are interchangeable.

Fitting notes

Rest the weldment in a clean, square shell and locate the bearings without tightening. Work the 1730 mm tube through manual turns, watching the helix keep a steady gap the whole way. When the drive is coupled, confirm the turning sense agrees with the helix hand so grain climbs. The mounts are locked only after a completely free hand run, and the bearings take lubricant per the manual.

Before you fit it

Inspect the matching auger shell for thinning or pin-holing before fitting a new auger.

Signs it needs replacing

  • Grain falling back and a slower fill from a worn edge
  • Enlarged clearance inside the 130 mm shell
  • A bent or out-of-true shaft rubbing the shell
  • Bearing wear at the lift mounts

Compatibility and cross reference

Models covered

Listed for the FM WORLD 4LZ-6.0P Ruilong small grain tank; confirm the 1730 mm and 130 mm flight.

Confirming the right part

Match W3.5H-02HA-10A-01-03-00 and 1730 mm. A 1680 mm part is the 2500 for a different shell.

Reading the old part

1730 x 130 mm, 12 kg, and 50 mm longer than the 1680 mm auger with the same diameter. Because the diameter matches, length is the only usable check — and it is exactly the figure an operator estimates wrong by eye.

Questions we are asked about this auger

Are the 130 mm lifting augers interchangeable between small tanks?

Not by diameter alone. The 2507 is 1730 mm and the 2500 is 1680 mm for different shells, so match the part number and length rather than fitting on the 130 mm flight alone.

Related parts