,

Grain Lifting Auger (W3.5H-02PD-10-01-03-00)

small grain tank lifting auger. In-stock replacement for the FM WORLD harvester. Order by part number; contact us for exact fitment.

Grain Lifting Auger W3.5H-02PD-10-01-03-00 — 1680 mm, 11.8 kg

At 1680 mm this is the shorter of the two 130 mm-flight augers that fill the small tanks on the FM WORLD 4LZ-6.0P Ruilong, and it weighs 11.8 kg. It spins inside a housing built to its own length and carries grain upward into the tank. Although its 130 mm helix matches the 2507 in diameter, the 50 mm difference in length means each belongs to its own housing.

Specifications

Part numberW3.5H-02PD-10-01-03-00
TypeSmall grain tank lifting auger
Length x diameter1680 mm x 130 mm
Weight11.8 kg
FitsFM WORLD 4LZ-6.0P (Ruilong) Combine Harvester
AvailabilityIn stock, ready to ship

What this auger does

Because the grain has to climb, each turn of the helix must keep a firm grip on the column. Once the flight edge wears thin and the gap to the shell widens, some of that grain slips back down and the tank takes longer to fill. The 1680 mm tube is what separates this weldment from the 1730 mm 2507, even though both carry a 130 mm helix and are matched to shells of their own length.

The 1680 mm auger against the 1730 mm 2507

The two share a 130 mm flight and look very similar, but this 2500 is 1680 mm for the 10-position shell and the 2507 is 1730 mm for the 10A shell. Fitting on flight diameter alone risks a part that will not seat, so the number and length must be matched.

Fitting notes

Seat the weldment in a clean, square shell with the bearings still free, then work the 1680 mm tube through hand rotations and watch the helix run at a steady gap before locking the mounts. On coupling the drive, check the turning sense suits the helix hand and lifts the grain instead of letting it fall. The bearings are oiled per the manual and the helix stays dry.

Before you fit it

Inspect the matching housing for thinning before fitting the new auger.

Signs it needs replacing

  • The 130 mm helix losing its grip and grain dropping back as it climbs
  • Worn flight edges opening the shell clearance
  • A bent shaft causing the flight to rub
  • Rough or noisy bearings where the lift mounts support the tube

Compatibility and cross reference

Models covered

Fits the small tank housing on the FM WORLD 4LZ-6.0P Ruilong; check the 1680 mm length and 130 mm helix before ordering.

Confirming the right part

Match W3.5H-02PD-10-01-03-00 and 1680 mm. A 1730 mm part is the 2507.

Reading the old part

1680 x 130 mm, 11.8 kg. This is the smaller of the two small-tank lifting augers; the other is 1730 x 130 mm. Fifty millimetres is the whole difference, so lay a tape on both before deciding which tank they came from.

Questions we are asked about this auger

How do I tell this apart from the other 130 mm lifting auger?

By length and part number rather than diameter: this is 1680 mm (W3.5H-02PD-10-01-03-00), the other is 1730 mm. Match the shell and the number.

Related parts