,

Lifting Auger Weld (W3.5H-04HX-02-02-00)

grain tank lifting auger weld. In-stock replacement for the FM WORLD harvester. Order by part number; contact us for exact fitment.

Lifting Auger W3.5H-04HX-02-02-00 — 1770 mm, 12 kg

This is the lifting auger that raises grain inside the grain tank fill system on the FM WORLD 4LZ-6.0P Ruilong. It is 1770 mm long with a 162 mm diameter and weighs 12 kg, turning within its housing to carry grain up into the tank. It pairs with a dedicated housing weld and sits in the grain tank section of the conveyor system rather than the cleaning shoe.

Specifications

Part numberW3.5H-04HX-02-02-00
TypeGrain tank lifting auger
Length x diameter1770 mm x 162 mm
Weight12 kg
FitsFM WORLD 4LZ-6.0P (Ruilong) Combine Harvester
AvailabilityIn stock, ready to ship

What this auger does

The lifting auger works against gravity like the vertical elevator, so the flight face must keep positive contact with the grain. A worn outer edge opens the housing clearance and lets grain fall back, reducing the fill rate into the tank. At 162 mm it is a wider flight than the 125 mm vertical elevator, reflecting the higher tank-fill capacity.

The 162 mm tank lift auger against the 125 mm vertical elevator

This 1770 mm, 162 mm auger fills the grain tank at high capacity, while the 2379 vertical elevator is 1675 mm with a 125 mm flight and feeds from the cleaning shoe. They occupy different housings and are not interchangeable despite both lifting grain.

Fitting notes

Guide the weldment into a clean housing and square the bearings before locking them. Manual turns of the 1770 mm tube should reveal a uniform gap throughout. On coupling the drive, make sure it turns the way the helix is handed so the grain climbs rather than dropping. The bearings take lubricant per the manual and the helix stays uncoated.

Before you fit it

Inspect the matching lifting housing for thinning, since a worn housing will not be fixed by a new auger.

Signs it needs replacing

  • Reduced tank fill rate as grain slips back through a worn edge
  • Enlarged flight-to-housing clearance
  • A bent shaft causing the flight to rub
  • Bearing wear at the lift mounts showing as runout

Compatibility and cross reference

Models covered

Listed for the FM WORLD 4LZ-6.0P Ruilong grain tank; confirm the 1770 mm and 162 mm dimensions.

Confirming the right part

Match W3.5H-04HX-02-02-00 and the 162 mm diameter. A 125 mm part is the cleaning-shoe elevator, not this lift.

Reading the old part

1770 x 162 mm, 12 kg. Only the length and the diameter are listed, and both are within a few millimetres of the 1680 x 130 mm and 1730 x 130 mm lifting augers — measure both figures, because one alone will not separate them.

Questions we are asked about this auger

The tank fills slowly even though the elevator is delivering grain. Why?

The tank lifting auger may have worn flight edges that let grain fall back. Check the edge clearance and the rotation direction before the housing.

Related parts