,

Chain (10A-40)

Chain 10A-40. In stock for FM WORLD 4LZ-6.0P. Order by part number, contact us for fitment help.

Roller Chain 10A-40 for FM WORLD 4LZ-6.0P

This is a single-strand roller chain to the 10A standard with 40 links, weighing 0.6 kg and used in the grain tank system of the FM WORLD 4LZ-6.0P. The 10A gives the chain size and 40 is the number of pitches.

Chain specification

Part number10A-40
Part typeSingle-strand roller chain
Standard10A (ISO/ANSI)
Links40 pitches
Weight0.6 kg
FitsFM WORLD 4LZ-6.0P (Ruilong)

Inside a roller chain

Rollers turn on bushes that are fixed to the inner plates, while pins hinge the outer links, so the chain flexes freely yet pulls strongly. As the sprocket turns, the rollers seat in the tooth gaps and the load is spread across the engaged teeth.

Reading the size and link count

The 10A marks the chain size and the 40 counts the pitches, so both must match: a chain with the right size but wrong link count will not fit the loop. Count the links rather than measuring only the length.

Fitting the loop

Join the loop with the correct connecting link and set it square on the sprockets, then tension to the manual and rotate by hand to confirm the rollers seat in every tooth.

Lubricate the joints and keep them clean, and check the sprocket teeth are not hooked, since a worn wheel will shorten the life of the new chain.

When a roller chain is changed

  • Elongation as the pin and bush joints wear
  • Jumping or climbing the teeth when stretched
  • Stiff or seized links
  • Noise and chain slap from slack
  • Cracked plates or a damaged roller
  • Rust and dry joints from poor lubrication

Ordering information

Mounting: Looped over the grain tank drive sprockets of the FM WORLD 4LZ-6.0P.

Verify: Verify part number 10A-40 and count the 40 pitches.

Dimensions to match: Match the 10A size and the exact link count to the sprockets and loop.

Related unloading parts

Questions answered

What do 10A and 40 mean?

10A is the ISO/ANSI chain size and 40 is the number of pitches in the loop, so the figure after the dash counts links rather than length.

Does a new chain need a new sprocket?

Only if the teeth are hooked or worn. Inspect them first, because a worn sprocket will quickly destroy a fresh roller chain.

10A-40 identification before ordering

Read the size and count the links, since a worn loop can look longer than it should. Send the number and a photo through the quote form and the correct chain will be confirmed.

Request a Quote Now