,

Conveyor Chain (W3.5-01A-02-09-01(2060-84))

Chain W3.5-01A-02-09-01. In stock for FM WORLD 4LZ-6.0P. Order by part number, contact us for fitment help.

Conveyor Chain for FM WORLD 4LZ-6.0P Header

This conveyor chain is the bare link loop for the FM WORLD 4LZ-6.0P header, 3160 mm long and 70 × 25 mm in section, weighing 4.2 kg. It runs over the header sprockets and carries the crop through the conveyor.

Chain dimensions

Part numberW3.5-01A-02-09-01
Part typeConveyor chain
Length3160 mm
Section70 × 25 mm
Weight4.2 kg
FitsFM WORLD 4LZ-6.0P (Ruilong)

How the links articulate

Pins join the links and let them articulate as the loop turns, while the hardened bearing surfaces carry the pull of the loaded conveyor. Each joint flexes twice on every pass around the sprockets, which is where the working wear is concentrated.

Chain elongation against sprocket wear

As the pin and bush surfaces wear, the pitch grows and the chain elongates until it no longer sits on the teeth. A stretched chain and a hooked sprocket reinforce each other, so check the teeth before fitting a fresh chain.

Joining and tensioning

Join the loop with the correct link and lay it square on both sprockets, then set the tension to the manual so there is neither slap nor excessive pull. Turn it by hand through a full cycle.

Lubricate the joints as specified and keep the chain clean, since grit at the articulating joints accelerates the wear that causes elongation.

Signs of a worn chain

  • Elongation that lets the chain jump or climb
  • Stiff links that snatch around the sprockets
  • Chain slap and noise from slack tension
  • Cracked or stretched link plates
  • Rust or dried lubricant at the pins
  • Uneven running that pulls the loop to one side

Ordering details

Mounting: Looped over the header sprockets of the FM WORLD 4LZ-6.0P in the conveyor housing.

Verify: Verify part number W3.5-01A-02-09-01 and the 3160 mm length.

Dimensions to match: Match the length and section and confirm the pitch fits the sprockets.

Related header parts

Common questions

What actually wears in a conveyor chain?

The pin and bush surfaces at each joint, which let the pitch grow until the chain elongates and will not seat on the teeth.

How is correct tension judged?

To the service manual value: enough to stop slap and jumping without overloading the shaft bearings, then checked by turning the loop.

W3.5-01A-02-09-01 identification before ordering

Read the part number on a link and measure the length and section. If the marking is worn, send the number and a photo through the quote form and the correct chain will be matched.

Request a Quote Now