,

Chain Wheel Weld (W2.5E-01B-01-04-11-00)

Chain W2.5E-01B-01-04-11-00. In stock for FM WORLD 4LZ-6.0P. Order by part number, contact us for fitment help.

Chain Wheel Weld (Sprocket) for FM WORLD 4LZ-6.0P Header

This welded chain wheel is the toothed sprocket that drives the header chain on the FM WORLD 4LZ-6.0P, measured at 230 mm across the teeth with a 40 mm hub and weighing 2 kg. Its teeth engage the chain rollers and turn the conveyor.

Sprocket dimensions

Part numberW2.5E-01B-01-04-11-00
Part typeWelded sprocket (chain wheel)
Tooth diameter230 mm
Hub40 mm
Weight2 kg
FitsFM WORLD 4LZ-6.0P (Ruilong)

How the wheel drives the chain

Each tooth is shaped to seat a chain roller in the gap between teeth, so as the shaft turns the wheel pulls the chain one pitch at a time. The welded body fixes the toothed ring to its hub and keeps the teeth concentric with the shaft, which is what lets the chain run smoothly without climbing.

Worn sprocket against a worn chain

A chain and sprocket wear together, so fitting a new chain over a hooked sprocket simply wears the fresh chain. Inspect the teeth before deciding whether only the chain is needed, and replace the wheel when the teeth are thin or sharply hooked.

Fitting and alignment

Mount the wheel square on its shaft and confirm it runs true, with the chain centred on the teeth rather than riding to one side. Check the key and fasteners are secure before tensioning.

After fitting, set the chain tension to the service manual value and confirm the links seat fully in every tooth, then rotate by hand to watch for any climb or snatch.

Symptoms of a worn wheel

  • Hooked or pointed teeth that no longer seat the rollers
  • Thin tooth tips worn thin by a stretched chain
  • A wobble from a loose hub or worn key
  • Chain climbing or jumping the teeth
  • Uneven wear that pulls the chain to one side
  • Noise and snatch as the links fail to seat

Ordering details

Mounting: Bolted to the header drive shaft of the FM WORLD 4LZ-6.0P, meshing with the conveyor chain.

Verify: Verify part number W2.5E-01B-01-04-11-00 and the 230 mm tooth diameter.

Dimensions to match: Match the tooth pitch to the chain and check the hub bore and keyway.

Related header parts

Common questions

Why do the teeth look hooked?

As the joints wear and the chain elongates, it rides higher on the teeth and wears them into a hook shape, which then ruins a new chain.

Should the wheel be changed with the chain?

If the teeth are hooked or thin, yes. A new chain on a worn sprocket fails early, so both are assessed together.

W2.5E-01B-01-04-11-00 identification before ordering

Read the part number on the hub and measure the tooth diameter and bore. If the marking is worn, send the number and a photo through the quote form and the correct sprocket will be confirmed.

Request a Quote Now