Shaft Sleeve W2.5E-01B-02-40 (40 mm Length, 80 mm Diameter)
The W2.5E-01B-02-40 shaft sleeve is 40 mm long, 80 mm in diameter and 0.1 kg, used as a protective sleeve at the shaft location.
Sleeve wear data
| Part number | W2.5E-01B-02-40 |
| Component | Shaft sleeve |
| Length | 40 mm |
| Diameter | 80 mm |
| Mass | 0.1 kg |
| Part type | Sleeve |
Shaft sleeve role
The sleeve provides a renewable wearing surface, protecting the mating bore or shaft area from direct contact and galling.
Shaft sleeve differences
Unlike a shaft, the sleeve does not transmit rotation as the main supported axis; it protects the contact surface.
Shaft sleeve installation
Clean the seating area thoroughly and check that the sleeve is not burred or out of round before pressing it into position.
After fitting, confirm the sleeve is seated fully and the mating shaft moves without catching on its edge.
Shaft sleeve wear checks
- Inner wall wear
- Outer diameter looseness
- Burr at the edge
- Corrosion in the seat
- Cracking
- Galling after inadequate lubrication
Shaft sleeve ordering checks
W2.5E shaft sleeve location.
Before ordering, confirm W2.5E-01B-02-40 together with the 40 mm length, 80 mm diameter and 0.1 kg mass.
Match the sleeve outer diameter, inner opening, length and seating depth with the worn part.
Shaft sleeve related parts
Shaft sleeve questions
Is this a bearing?
It is a shaft sleeve, not a rolling bearing.
Can a worn sleeve be left in place?
A loose or damaged sleeve can accelerate shaft and bore wear.
Identification of W2.5E-01B-02-40 before ordering
Use this sleeve when the contact surface is worn or loose, and the main shaft remains serviceable.





