,

Conveyor Chain Wheel W2.5E-01B-02-04Y

Conveyor chain wheel at the head. Part W2.5E-01B-02-04Y. In-stock replacement for the FM WORLD 4LZ-6.0P header and threshing system.

Conveyor Chain Wheel (W2.5E-01B-02-04Y) for the FM WORLD 6.0P

This is the conveyor sprocket at the head, 170 mm overall with a 55 mm hub and 13 teeth, carrying 60 mm and 40 mm bores at its mounting positions. It weighs 2.35 kg, far more than the other sprockets, and it is the member the conveyor chain turns around at the head.

Specifications

Part NumberW2.5E-01B-02-04Y
Part TypeConveyor chain wheel
Overall Diameter170 mm
Mounting Bores60 / 40 mm
Hub Height55 mm
Teeth13
Weight2.35 kg
FitsFM WORLD 4LZ-6.0P (Ruilong)
AvailabilityIn stock, ready to ship

What this part does

A large sprocket with few teeth is a heavily loaded part: the conveyor pulls across 13 teeth, and the load is concentrated on a small number of them at any moment. Wear shows at the tooth profile as hooking, and because the hub is 55 mm long the fit to the shaft and the mounting bores decide whether the sprocket turns true. A sprocket that runs off true wears the conveyor chain on one side and the chain starts to wander on the head.

The large head sprocket and the small drive sprockets

The other sprockets are 62 to 120 mm with single bores; this one is 170 mm, 55 mm across the hub and carries 60 / 40 mm mounting bores. Its size and weight make it easy to identify, but the 13-tooth count is the figure to check against the conveyor chain, since the chain is ordered to match it.

Fitting notes

Check the mounting bores and the keyways before fitting, and confirm the sprocket turns true on the shaft rather than on a worn shoulder. Inspect the conveyor chain for elongation and the take-up sprocket before the head is closed. Alignment and tension follow the service manual, and the guard is refitted after a hand check.

Before you fit it

Because this sprocket is heavy, support it while fitting rather than letting it hang on the shaft, and confirm both mounting bores are clean before it is seated.

Signs it needs replacing

  • Hooking across the 13 working teeth
  • Conveyor chain wandering or wearing on one side
  • Worn mounting bores or a sprocket that runs off true
  • Knock at the head as the chain enters the teeth

Compatibility and cross reference

Models covered

The head sprocket of the conveyor on the FM WORLD 4LZ-6.0P, a 13-tooth, 170 mm part with 60 / 40 mm mounting bores. The conveyor chain is matched to it.

Confirming the right part

Confirm W2.5E-01B-02-04Y on 13 teeth, 170 mm overall and the 60 / 40 mm bores. The smaller sprockets are different parts.

Reading the old part

The size and the 13-tooth count identify this sprocket; measure the mounting bores at 60 and 40 mm before fitting.

Questions we are asked about this part

Why does a large sprocket have only 13 teeth?

The tooth count is set by the conveyor chain and the head geometry; the large diameter carries the chain around the head rather than setting a high ratio. The chain is matched to this count.

Is this sprocket replaced with the chain?

If the teeth are still clean and the bores are true, it can stay; hooked teeth or worn bores mean replacing it with the chain, since a new chain on a hooked head wears quickly.

Related parts