,

Roller Chain 08B-1×98 (98 Joints)

08B single roller chain with 98 joints. Part 08B-1×98. In-stock replacement for the FM WORLD 4LZ-6.0P header and threshing system.

Chain 08B-1×98 (98 Joints) for the FM WORLD 6.0P

This is a single-strand 08B roller chain with 98 joints, weighing 0.9 kg. It is the shorter of the two 08B lengths on this machine. The 114-joint chain is the same series and the same construction, so the joint count, not the appearance, decides which one fits.

Specifications

Part Number08B-1×98
Part TypeSingle-strand roller chain
Series08B
Joints98
Weight0.9 kg
FitsFM WORLD 4LZ-6.0P (Ruilong)
AvailabilityIn stock, ready to ship

What this part does

On this shorter run the chain bends through the same cycles as the longer one, so the hinge wear is identical, but the take-up geometry is tighter. A little elongation here uses up the adjustment travel sooner because the run is shorter. The warning signs are the same as for any roller chain: the chain climbs the teeth, then jumps, and the sprocket tips begin to show hooked wear. Catching it at the climb stage saves the sprockets; waiting until it jumps does not.

Why the shorter chain needs the same inspection

Because both chains are 08B, it is tempting to assume the longer one wears first. Wear depends on cycles and load, not on length, and the two runs are driven at different points. Inspect each chain on its own sprockets and count its own joints; never swap a length across runs to keep the machine moving, because tension and wrap are set for the original count.

Fitting notes

Flex the chain through your hands to expose stiff links before fitting, and look at the sprocket tooth profile for hooking. Confirm the shafts are parallel, since misalignment on a short run shows quickly as side wear on the plates. Tension and alignment figures follow the service manual. Fit the connecting link correctly and lubricate before the machine is run.

Before you fit it

A short run has little room for error in alignment. Check the sprockets face each other square before closing the guard, because a misaligned chain wears the inner plates and the teeth on one side.

Signs it needs replacing

  • Teeth climbing and jumping on the shorter run
  • Adjustment travel already used up with the chain still slack
  • Side wear on the inner plates from misalignment
  • Stiff, rusted or discoloured hinges

Compatibility and cross reference

Models covered

The 98-joint 08B chain in the header and conveyor drive of the FM WORLD 4LZ-6.0P. The 114-joint version is longer and belongs to the other run.

Confirming the right part

Confirm 08B-1×98 on 98 joints and 0.9 kg. The 114-joint chain is a different length and cannot be adjusted down to this run.

Reading the old part

Count the joints of the old chain end to end. Two 08B chains loose on the same pallet are indistinguishable by eye, and the count is the only separator.

Questions we are asked about this part

The 114-joint chain is in stock. Can I shorten it?

Shortening a chain by removing links is possible in principle, but the cut end and the new connecting link change the chain from a factory length, and getting the joint count wrong leaves it either too short to close or slack at the end of adjustment. Ordering the correct length is safer.

How often should this chain be checked?

At the service intervals in the manual, and immediately if it starts to jump. The check is visual: hinge wear, stiff links and the sprocket tooth profile.

Related parts