,

Conveyor Teeth,Right (W2.5E-01D-01-03-01)

Part W2.5E-01D-01-03-01. In stock for FM WORLD 4LZ-6.0P. Order by part number, contact us for fitment help.

Right-Hand Conveyor Tooth Bar (1215 mm) for FM WORLD 4LZ-6.0P

This long right-hand conveyor tooth bar is 1215 x 68 x 2.5 mm and 0.9 kg, bolted to the conveyor chain to sweep cut material along the feeder.

Bar dimensions

Part numberW2.5E-01D-01-03-01
Part typeRight-hand conveyor tooth bar
Length1215 mm
Width / thickness68 / 2.5 mm
Weight0.9 kg
FitsFM WORLD 4LZ-6.0P (Ruilong)

Sweeping the material

As the chain runs, the tooth face pushes the cut material uphill in an even curtain, so the long bar has to stay flat to keep the sweep consistent across the feeder width.

Right hand and why it matters

The right-hand bend matches one side of the conveyor; a left-hand bar curves the opposite way and will not seat on the same mountings, so the hand must be matched.

Mounting the bar

Bolt the bar to its chain seats and confirm it sits flat with the face square, then check the clearance to the conveyor shell is even.

Run the chain slowly and confirm the bar does not rub at either end, then watch it under load for a steady sweep.

When it is replaced

  • A bent or twisted bar after a stone impact
  • Worn or enlarged bolt holes
  • A cracked or thinned tooth face
  • Material leaking past a bar that no longer sits flat
  • Rubbing marks along the shell
  • Corrosion thinning the plate

How to order

Mounting: Feeder conveyor on FM WORLD 4LZ-6.0P (Ruilong) combine harvesters.

Confirmation: Give the part number and the 1215 mm length and confirm the right-hand fit.

Dimensions to match: Check the length, width, thickness and the bend direction against your old bar.

Conveyor tooth and arm parts

  • Part 2299
  • Common questions

    Can the left-hand bar be fitted here?

    No, the bends oppose each other and the mountings will not line up; match the right-hand part.

    Why is the bar so thin?

    It is a plate tooth rather than a structural beam, sized to sweep the crop while the chain carries the load.

    Identification of W2.5E-01D-01-03-01 before ordering

    Replace this tooth bar when it is bent, cracked or its holes are worn; a flat bar that sweeps evenly can remain.

    Request a Quote Now