,

Chain Wheel 14 Teeth W2.0-02-11-07

14-tooth chain wheel (sprocket). Part W2.0-02-11-07. In-stock replacement for the FM WORLD 4LZ-6.0P header and threshing system.

14 Chain Wheel (W2.0-02-11-07) for the FM WORLD 6.0P

This is a 14-tooth sprocket, 62 mm outside, 20 mm bore and 26 mm across the hub, weighing 0.1 kg. With only 14 teeth it is the smallest of the sprockets on this machine, and small sprockets wear differently from large ones because each tooth meets the chain more often.

Specifications

Part NumberW2.0-02-11-07
Part TypeChain wheel, 14 teeth
Outside Diameter62 mm
Bore20 mm
Hub Height26 mm
Teeth14
Weight0.1 kg
FitsFM WORLD 4LZ-6.0P (Ruilong)
AvailabilityIn stock, ready to ship

What this part does

On a small sprocket every tooth cycles more times per revolution, so the tooth profile changes first here. The tips wear into a hooked shape, and once that happens the chain does not leave the tooth cleanly: it is dragged and then released, which is felt as a regular knock rather than heard as a whine. Because the bore is only 20 mm, a worn keyway also matters; a sprocket turning on its key quickly opens the bore and the chain runs with a pulse.

The 14-tooth sprocket and the larger sprockets

The 17-tooth and 22-tooth sprockets have larger bores and more teeth sharing the load; this one is 62 mm outside with a 20 mm bore. The three measurements and the tooth count together identify it, and a sprocket with the right bore but the wrong tooth count changes the chain speed at that position.

Fitting notes

Check the key and the keyway before fitting and confirm the bore seats without rocking, then look at the chain that will run on it: a worn chain on a new sprocket hooks the new teeth quickly. The sprocket is fitted square and the chain tension follows the service manual. Confirm the guard clears the teeth after fitting.

Before you fit it

Inspect the keyway as carefully as the teeth. A sprocket with good teeth and a worn keyway still turns loose and feeds a pulse into the chain.

Signs it needs replacing

  • Hooked or thinned tooth tips
  • Regular knock as the chain leaves the teeth
  • Worn keyway or a bore that rocks on the shaft
  • Chain wear concentrated at the small sprocket

Compatibility and cross reference

Models covered

The 14-tooth sprocket in the threshing and elevator drive of the FM WORLD 4LZ-6.0P. The larger sprockets carry different tooth counts and part numbers.

Confirming the right part

Confirm W2.0-02-11-07 on 14 teeth, 62 mm outside and 20 mm bore. A sprocket with the same bore but more teeth changes the drive ratio.

Reading the old part

Count the teeth and measure the bore. The 14-tooth count and 20 mm bore separate it from the 17- and 22-tooth parts.

Questions we are asked about this part

Do I replace the sprocket when I replace the chain?

On a small sprocket, yes if the teeth are already hooked. The chain and sprocket wear as a pair, and a new chain on hooked teeth loses life quickly. If the profile is still clean, the sprocket can stay.

How is a 14-tooth sprocket identified?

Count the teeth and measure 62 mm outside, 20 mm bore and 26 mm hub. The tooth count is the fastest check against the larger sprockets.

Related parts