,

Input Shaft (WD-150A-03A.05.10.01-01)

Shaft WD-150A-03A.05.10.01-01. In stock for FM WORLD 4LZ-6.0P. Order by part number, contact us for fitment help.

Input Shaft for FM WORLD 4LZ-6.0P Threshing Assembly

This input shaft is the entry point that carries drive into the threshing assembly of the FM WORLD 4LZ-6.0P, 155 mm long with 15 mm end journals and a 25 mm middle section, weighing 0.29 kg. Its shoulders locate the mounted drive part and the torque passes through it.

Shaft dimensions

Part numberWD-150A-03A.05.10.01-01
Part typeInput shaft
Length155 mm
End journals15 mm
Middle section25 mm
Weight0.29 kg
FitsFM WORLD 4LZ-6.0P (Ruilong)

How power enters the assembly

The drive torque is applied at one end and carried through the shaft to the mounted gear or pulley, while the machined shoulders hold that part in the correct position. The journals run in bearings that support the shaft as it rotates under load.

Shoulders, keys and torque

Steps in the diameter are locating surfaces rather than decoration, and the keyway locks the mounted part so it cannot turn on the shaft. Each change of section is a point where stress is concentrated, which is why cracks are checked there.

Fitting the shaft

Fit the bearings square on the journals and slide the driven part home against its shoulder, then secure the key and fasteners. Confirm the shaft turns freely and the alignment is true before the cover is fitted.

Avoid striking the shaft directly, and set any fastener torque to the service manual. After assembly, rotate by hand to confirm there is no bind or runout.

Why an input shaft is replaced

  • A fatigue crack starting at a keyway or shoulder
  • A bent shaft from an overload or impact
  • A worn or scored bearing journal
  • A damaged or rounded keyway
  • Visible runout and vibration
  • Noise or bind as the shaft rotates

Ordering details

Mounting: It runs through the threshing housing, where its bearings support the input drive and the mounted part turns against the locating shoulder.

Verify: Verify part number WD-150A-03A.05.10.01-01 and the 155 mm length.

Dimensions to match: Before fitting, confirm the 15 mm journals and 25 mm middle section match the bearings and the keyway fits the drive part.

Related threshing parts

Common questions

What does an input shaft do?

It is the first rotating part that receives drive and carries torque into the threshing assembly, with shoulders locating the mounted part.

Where do these shafts fail?

Usually at a stress concentration such as a keyway or diameter step, where fatigue cracks begin under repeated bending and torque.

WD-150A-03A.05.10.01-01 identification before ordering

Identification is straightforward: the short 155 mm shaft with 15 mm journals is the input part. Quote the stamped number WD-150A-03A.05.10.01-01, or send a clear photo and the dimensions if the stamping has worn away.

Request a Quote Now