,

Driven Shaft (W2.5-02S-01-17-09)

Shaft W2.5-02S-01-17-09. In stock for FM WORLD 4LZ-6.0P. Order by part number, contact us for fitment help.

Driven Shaft for FM WORLD 4LZ-6.0P Threshing Assembly

This driven shaft carries the rotating parts of the threshing assembly on the FM WORLD 4LZ-6.0P, 280 mm long with 35 mm end journals and a 50 mm middle section, weighing 2.8 kg. It turns under both torque and the bending load of the parts it carries.

Shaft specification

Part numberW2.5-02S-01-17-09
Part typeDriven shaft
Length280 mm
End journals35 mm
Middle section50 mm
Weight2.8 kg
FitsFM WORLD 4LZ-6.0P (Ruilong)

Carrying the driven parts

The mounted parts are located along the shaft and turn with it, so the driven shaft both transmits torque and resists the sideways pull of those parts. The journals are supported in bearings, which keep the whole assembly running on its axis.

Bending and torsion together

A driven shaft sees torsion from the torque and bending from the forces on its mounted parts at the same time, so it is inspected for both twist-related and deflection-related damage rather than only one kind.

Mounting and support

Support the shaft on its bearings and confirm each mounted part seats against its shoulder with the key engaged, then fit the retaining fasteners. Check the shaft rotates without bind.

Set fastener torque to the service manual and confirm the alignment with the mating parts, then rotate by hand to check for runout or rubbing.

Replacement symptoms

  • Bending or runout from a heavy load
  • Fatigue cracking at a shoulder or keyway
  • Worn journals that leave play in the bearings
  • A sheared or damaged key
  • Vibration and noise under load
  • Scoring or galling on the bearing seats

Ordering information

Mounting: It sits inside the threshing housing carrying the driven parts, with the 35 mm journals supported in bearings on either side.

Verify: Verify part number W2.5-02S-01-17-09 and the 280 mm length.

Dimensions to match: Check the 35 mm end journals and the heavier 50 mm middle section against the bearings, and confirm the keyway positions line up with the parts it drives.

Related threshing parts

Questions answered

How is a driven shaft different from an input shaft?

It sits further into the assembly and carries the driven parts, working under both torque and the bending load of those parts.

What is the main check before fitting?

The journals for wear, the shoulders and keyways for cracks, and the straightness, then bearing alignment on assembly.

W2.5-02S-01-17-09 identification before ordering

At 280 mm this is the longer of the two threshing shafts, and the 50 mm middle section distinguishes it from the input part. Quote W2.5-02S-01-17-09; if it is hard to read, photograph the shaft next to a ruler and send it through the quote form.

Request a Quote Now