,

Shaft, Chain Wheel (L1.8A-03-04-03-03)

Shaft L1.8A-03-04-03-03. In stock for FM WORLD 4LZ-6.0P. Order by part number, contact us for fitment help.

Chain Wheel Shaft for FM WORLD 4LZ-6.0P Threshing Assembly

This shaft carries the chain wheel (sprocket) in the threshing assembly of the FM WORLD 4LZ-6.0P, 110 mm long with 24 mm end journals and a 30 mm middle section, weighing 0.4 kg. It supports the sprocket and withstands the pull of the chain.

Shaft dimensions

Part numberL1.8A-03-04-03-03
Part typeChain wheel shaft
Length110 mm
End journals24 mm
Middle section30 mm
Weight0.4 kg
FitsFM WORLD 4LZ-6.0P (Ruilong)

Supporting the sprocket

The sprocket is mounted on the middle section and keyed to the shaft, so as the chain pulls on the teeth the shaft carries that force and turns with the wheel. The journals run in bearings on either side of the sprocket.

Chain load on the shaft

A chain applies a sideways pull as well as torque, so the shaft is loaded in bending every time the chain tightens. A worn sprocket or a slack chain adds shock loads that accelerate wear at the journals and keyway.

Fitting the wheel and shaft

Fit the sprocket square against its shoulder with the key engaged, then support the shaft in its bearings and confirm the chain tracks the teeth without running off.

Set the chain tension to the service manual and confirm the shaft has no end play, then rotate by hand to watch for runout or chain climb.

Signs of a worn shaft

  • A worn keyway that lets the sprocket move
  • Scored journals and bearing play
  • Bending or runout from chain shock
  • A fatigue crack at the diameter step
  • Noise and snatch as the chain loads
  • The sprocket running out of true

Ordering information

Mounting: It is bolted within the threshing housing directly under the sprocket, with the chain wheel keyed to the middle section.

Verify: Verify part number L1.8A-03-04-03-03 and the 110 mm length.

Dimensions to match: Confirm the 24 mm journals and 30 mm middle section fit the bearings and the sprocket keyway, and check the chain tracks the wheel.

Related threshing parts

Questions answered

Why does a chain wheel shaft wear?

The chain applies a sideways pull and shock loads as it tightens, which work the journals and keyway even though the shaft is short.

Should it be changed with the sprocket?

Inspect both together. A worn keyway or journal will not hold a new sprocket, and a hooked sprocket will damage the chain.

L1.8A-03-04-03-03 identification before ordering

This short 110 mm shaft is identified by the sprocket it carries rather than a name on the part. Quote L1.8A-03-04-03-03, or photograph the shaft beside the chain wheel and include the journal measurements.

Request a Quote Now