Bevel Gear 20 Teeth for the FM WORLD 6.0P Threshing Drive
This is the 20-tooth bevel gear in the threshing drive, 64 mm outside, 20 mm bore and 50 mm across the hub, weighing 0.3 kg. Its longer hub and plain bore distinguish it from the 19-tooth splined gear it runs against.
Specifications
| Part Number | W2.5-02-03-02-02 |
|---|---|
| Part Type | Bevel gear |
| Outside Diameter | 64 mm |
| Bore | 20 mm |
| Hub Height | 50 mm |
| Teeth | 20 |
| Weight | 0.3 kg |
| Fits | FM WORLD 4LZ-6.0P (Ruilong) |
| Availability | In stock, ready to ship |
What this part does
The tooth faces wear in the same way as the larger gear: pitting, scoring and a slowly opening backlash, with noise as the first audible sign. Because this gear mounts on a plain 20 mm bore with a key, the key and keyway are the parts to check alongside the teeth. A keyway that has opened lets the gear index on the shaft, and the repeated shock is harder on the teeth than the steady load. The 50 mm hub also has to run true; a bent shaft or a worn hub shows as a pattern that is heavier on one side of the teeth.
The 20-tooth gear and the 19-tooth splined gear
This gear is smaller, with a 20 mm keyed bore and a long hub; the driven gear is 92 mm with a 32 mm spline. The two are a matched mesh, and neither the bore nor the tooth count can be swapped. Confirming both parts together is the safe way to order.
Fitting notes
Check the key, keyway and shaft before fitting, then verify the contact pattern and the backlash against the service manual. The gear is seated fully on its shaft and the housing filled with the specified oil. A worn mating gear should be replaced in the same job.
Before you fit it
The long hub makes shaft condition important. Measure the journals and check the keyway before the gear goes on, since a loose hub feeds a shock into the mesh.
Signs it needs replacing
- Pitting or scoring on the conical faces
- Growing whine from opening backlash
- A keyway that has opened or a loose key
- Contact pattern heavy on one side of the teeth
Compatibility and cross reference
Models covered
The 20-tooth bevel gear in the threshing drive of the FM WORLD 4LZ-6.0P, meshing with the 19-tooth driven gear.
Confirming the right part
Confirm W2.5-02-03-02-02 on 20 teeth, 64 mm outside and the 20 mm keyed bore. The splined gear is a different part.
Reading the old part
Count the teeth and measure the plain bore. Twenty teeth and the 20 mm keyway separate this gear from the splined one.
Questions we are asked about this part
Can this gear be replaced on its own?
Only if the mating 19-tooth gear is still clean and the contact pattern is even. Once either member is pitted or scored, the pair is replaced together, since they were lapped as a set.
What does a one-sided contact pattern mean?
Usually a shaft or alignment problem rather than a worn gear. The mounting and shaft should be checked before a new gear is fitted, or the new gear will wear the same pattern.





