,

Driving Chain Wheel 17 Teeth L1.8A-03-02-01-04A

17-tooth driving chain wheel. Part L1.8A-03-02-01-04A. In-stock replacement for the FM WORLD 4LZ-6.0P header and threshing system.

Driving Chain Wheel 17 Teeth (L1.8A-03-02-01-04A) FM WORLD 6.0P

This is the driving sprocket on the chain run, with 17 teeth, a 74 mm outside diameter, a 22.5 mm bore and a 30 mm hub, weighing 0.3 kg. It is the member that puts power into the chain, so the chain’s load starts at its teeth.

Specifications

Part NumberL1.8A-03-02-01-04A
Part TypeDriving chain wheel, 17 teeth
Outside Diameter74 mm
Bore22.5 mm
Hub Height30 mm
Teeth17
Weight0.3 kg
FitsFM WORLD 4LZ-6.0P (Ruilong)
AvailabilityIn stock, ready to ship

What this part does

A driving sprocket wears under load rather than under coasting, so the working faces of its teeth show the load pattern clearly: bright bands where the chain pulls, and hooking as the wear reaches the tips. Because the bore is 22.5 mm, the fit to the shaft and the keyway decide whether the power goes in cleanly. A loose keyway shows as a knock at every start and stop, and running it loose opens the bore until the sprocket wobbles and the chain wears on one side.

Driver and driven sprockets

The 14-tooth sprocket is the smaller driven member, at 62 mm and 20 mm bore; this one is 74 mm, 22.5 mm bore and 17 teeth. They are not interchangeable, and swapping tooth counts changes the speed of the run. The bore size alone is enough to stop a wrong swap on the bench, but only if it is measured.

Fitting notes

Check the shaft, the key and the keyway before fitting, and confirm the sprocket seats fully against its shoulder. Inspect the chain that will run on it for elongation and the driven sprocket for hooking. Tension and alignment follow the service manual, and the guard is refitted only after the chain is checked by hand.

Before you fit it

Because this is the driving member, a worn keyway is felt at every engagement. Replace the key and check the bore before fitting rather than reusing a loose joint.

Signs it needs replacing

  • Bright load bands and hooked tips on the teeth
  • Knock at every start and stop from a worn keyway
  • Wobble or side wear once the bore has opened
  • Chain loading unevenly across the run

Compatibility and cross reference

Models covered

The 17-tooth driving sprocket in the threshing drive of the FM WORLD 4LZ-6.0P. It feeds power into the chain and is identified by its 22.5 mm bore.

Confirming the right part

Confirm L1.8A-03-02-01-04A on 17 teeth, 74 mm outside and 22.5 mm bore. The 14-tooth sprocket has a 20 mm bore and is a different part.

Reading the old part

Count the teeth and measure the bore. Seventeen teeth and a 22.5 mm bore separate this sprocket from the smaller and larger ones.

Questions we are asked about this part

Why is the bore 22.5 mm rather than a round number?

The bore is sized to the shaft it drives, and the half-millimetre is part of the fit rather than a tolerance. A sprocket bored to a different size will not seat on the shaft.

Should the driver be replaced before the driven sprocket?

Not by rule. Inspect both profiles; the driver often shows the load pattern first, but the driven sprocket can hook first on a short run. The chain condition decides whether both are replaced together.

Related parts