Chain 08B-1×114 (114 Joints) for the FM WORLD 6.0P
This is a single-strand 08B roller chain with 114 joints, weighing 1 kg. It is the longer of the two 08B chains used on this machine: the other length is 98 joints. The joint count is the figure that identifies it, because both chains share the same series and look identical loose on the bench.
Specifications
| Part Number | 08B-1×114 |
|---|---|
| Part Type | Single-strand roller chain |
| Series | 08B |
| Joints | 114 |
| Weight | 1 kg |
| Fits | FM WORLD 4LZ-6.0P (Ruilong) |
| Availability | In stock, ready to ship |
What this part does
A roller chain wears at its hinges, not at its plates. Every joint pivots as the chain bends onto and off the sprocket, and the pins and bushes slowly lose material there. The chain does not break; it grows. That elongation is the real failure mode: once the chain is longer than the sprocket pitch, it rides up the teeth, loads the wrong part of the tooth, and starts to jump. A chain that jumps under load can damage the sprocket it jumps on, which turns a cheap replacement into a larger one.
114 joints against 98 joints
The two 08B chains differ only in length, and a chain that is too short simply will not close, while a chain that is too long cannot be adjusted away: the take-up travel is fixed, and excess length leaves the chain slack at the end of the adjustment range. Count the joints of the old chain before ordering rather than judging by the box, and do not add links to a shorter chain to make it fit, because a joining link fitted in the middle of a run is the first link to fail.
Fitting notes
Lay the chain out and work it by hand before fitting to find stiff links, then check the sprocket teeth for the hooked shape that marks a worn sprocket. A new chain on a hooked sprocket wears to match it within a season. Alignment and tension follow the service manual, and the connecting link should be fitted with its closed end facing the direction of travel. Lubricate after fitting rather than running it dry.
Before you fit it
Check both sprockets, not just the chain. If the teeth are hooked or thinned at the tips, replace them together; the chain and its sprockets are one wearing system.
Signs it needs replacing
- Chain riding high on the sprocket teeth
- Jumping or skipping under load
- Slack that cannot be taken up within the adjustment range
- Stiff links or rust marks at the hinges
Compatibility and cross reference
Models covered
The 114-joint 08B chain in the header and conveyor drive of the FM WORLD 4LZ-6.0P. The shorter 98-joint chain is a separate part, so order by joint count.
Confirming the right part
Confirm 08B-1×114 on 114 joints and 1 kg. A chain of the same series with 98 joints is the other length and will not reach this run.
Reading the old part
There is no marking on a loose chain. Count every joint end to end; the count is the only reliable check once the packaging is gone.
Questions we are asked about this part
How do I confirm I need the 114-joint chain?
Count the joints of the old chain, including the connecting link. The 98-joint version is a different length and cannot be adjusted to fit this run.
Can I extend a shorter chain with extra links?
Not recommended. A second connecting link in the run is a weak point, and the chain’s tension is set assuming a single join. Order the correct length instead.





