Reel Belt Tension Pulley Assembly (70 mm) for FM WORLD 4LZ-6.0P
This small idler assembly holds the correct tension on the reel drive belt. It measures 85 mm overall with a 70 mm pulley and weighs only 0.32 kg, riding against the belt to stop it flapping or slipping.
Idler dimensions
| Part number | W2.5E-01B-01-15-00 |
| Part type | Belt tension pulley assembly |
| Overall size | 85 mm |
| Pulley diameter | 70 mm |
| Weight | 0.32 kg |
| Fits | FM WORLD 4LZ-6.0P (Ruilong) |
Keeping the belt tensioned
The pulley presses on the belt and takes up slack as the belt stretches, so the drive reaches the reel without flutter. It rotates freely on its own mount rather than transmitting power itself.
Idler versus drive pulley
At 70 mm this is the smaller idler and should not be confused with the 280 mm welded drive pulley; the idler guides and tensions the belt, whereas the drive pulley turns the reel shaft.
Mounting the idler
Bolt the assembly to its bracket and confirm the pulley contacts the belt squarely on the groove. It must turn freely with no hard spots before the tension is set.
Set the tensioner to the service-manual belt deflection and re-check after a short run, since a new belt beds in and the slack may need taking up once.
When to replace it
- A rough or seized pulley that drags on the belt
- Side play in the mount that lets the belt walk off
- A worn groove that no longer supports the belt
- Squeaking from the idler while the reel runs
- Belt flutter or repeated slip after adjustment
- A bent or corroded bracket
How to order
Mounting: Reel drive belt run on FM WORLD 4LZ-6.0P (Ruilong) combine harvesters.
Confirmation: Give the part number and the 70 mm pulley size; we confirm it matches the reel belt bracket.
Dimensions to match: Verify the overall size, pulley diameter and the mounting points against your old idler.
Other belt and reel parts
Common questions
Is the tensioner sold as a complete assembly?
Yes, it is the pulley and its mount together, ready to bolt to the reel belt bracket.
Why does my belt keep slipping after adjustment?
A seized or worn idler cannot maintain even pressure; check this pulley for hard spots or play before replacing the belt.
Identification of W2.5E-01B-01-15-00 before ordering
Replace this idler when it seizes, develops play or wears its groove; a free-turning pulley that holds the belt square can be retained.





